NIARMADA Nissan Armada manuals & owner information
Nissan Armada owner resource

Manuals, service information and practical owner guidance.

Fast access to Nissan Armada owner manuals, service procedures, maintenance references, technical information and practical guides for different Armada generations.

Browse manuals →
Nissan Armada manual library

Nissan Armada 2025-2026 Service and Repair Manual: Second Seatback

Nissan Armada 2025-2026 Service and Repair Manual / Body Interior / Seat / Second Seat (captain Seat) / Second Seatback

Disassembly and Assembly

CAUTION:

When disassemble, always use a remover tool that is made of plastic to prevent damage.

DISASSEMBLY

Remove armrest.Disengage fixing pawls using a remover tool (A), and then remove armrest cover.

: Pawl

Remove mounting bolt, and then remove armrest.

Remove inside and outside seat cushion finisher outer. Refer to Disassembly and Assembly.

Disengage fixing pawls using a remover tool (A), and then remove tether anchor finisher.

: Pawl

Disengage seatback trim fixing retainer .

Remove seatback lever unit.Apply protective tape (A) to prevent damage.

Disengage fixing pawl using a remover tool (A), and then remove seatback lever unit cap.

: Pawl

Remove seatback lever unit fixing screw .

Pull out seatback lever unit and seatback lever cable as a set according to order 1→2 indicated by arrows as shown in the figure.

Disconnect seatback lever cable fixing portions according to order 1→2 indicated by arrows as shown in the figure, and then remove seatback lever unit from seatback lever cable.

Open seatback trim fixing fasteners .

Remove headrest holders by raising it while pinching pawls from the bottom of headrest holders.

CAUTION:

Before removing headrest holders, check its orientation because it has installation direction (front/rear, left and right).

Disengage harness fixing clip of seatback, and then disconnect harness connector.

CAUTION:

Before performing removal operation, check the installation position of harness connector and harness fixing clip.

Remove seatback trim and pad as a set from seat frame assembly.

Remove hog rings, and then separate seatback trim and pad.

CAUTION:

  • Before removing hog rings, check its position because it should be installation in position.

  • Never disassemble seatback pad and seatback heater (if equipped).

Remove seatback lever unit escutcheon.

ASSEMBLY

Note the following items, and then assemble in the reverse order of disassembly.

CAUTION:

  • Never reuse hog ring after disassembly, using new hog ring.

  • Always install hog ring in position.

  • Use new hog ring if removed or crimped unsuccessfully.

  • Before installing headrest holders, check its orientation because it has installation direction (front/rear, left and right).

  • Be installed harnesses and harness fixing clips in position.

  • If harnesses clip be broken, replace with new clip and it install in position where marked before removing clip.

    Other materials

    Precautions
    Precautions for Removing Battery Terminal When disconnecting the 12V battery terminal, turn off the ACC power before disconnecting the 12V battery terminal, observing “How to disconnect 12V battery terminal” described below. NOTE: Some ECUs operate for a certain fixed time even after ignit ...

    Heater & Air Conditioning System Service Data and Specifications
    A/C compressor Model DENSO make 7SAS17C Type Variable displacement swash plate Displacement cm3 (cu in)/rev Maximum 170 (10.4) Direction of rotation Clockwise (viewed from clutch) Drive belt Poly V Lubricant Name ND-OIL12 (PAG) Capacity m (US fl oz, Imp fl oz) To ...

    Rear Window Defogger Does Not Operate but Both Door Mirror Defoggers Operate
    Diagnosis Procedure CHECK REAR WINDOW DEFOGGER Check rear window defogger. Refer to Component Function Check. Is the inspection result normal? YES>> GO TO 2. NO>> Repair or replace the malfunctioning parts. CONFIRM THE OPERATION Confirm the operation again. Is the inspection result nor ...