Disassembly and Assembly
DISASSEMBLY
Remove seatback trim and pad. Refer to Disassembly and Assembly.
Disengage seat cushion trim fixing retainers 
.
Disengage seat cushion trim fixing retainers .
Disengage harness fixing clip of seat cushion, and then disconnect harness connector.
CAUTION:
Before performing removal operation, check the installation position of harness connector and harness fixing clip.
Remove seat cushion trim and pad as a set from seat frame assembly.
Remove hog rings, and then separate seat cushion trim and pad.
CAUTION:
-
Before removing hog rings, check its position because it should be installation in position.
-
Never disassemble seat cushion pad and seat cushion heater (if equipped).
ASSEMBLY
Note the following items, and then assemble in the reverse order of disassembly.
CAUTION:
-
Always install hog ring in position.
-
Never reuse hog ring after disassembly, using new hog ring.
-
Use new hog ring if removed or crimped unsuccessfully.
-
Be installed harnesses and harness fixing clips in position.
-
If harnesses clip be broken, replace with new clip and it install in position where marked before removing clip.
Other materials
Cup holders
Basic information
CAUTION
In the Nissan Armada, avoid sudden acceleration or braking when using
the cup holders to prevent spills. Hot liquids may cause burns to you or your
passengers.
Use only soft or flexible containers in the Nissan Armada cup holders.
Hard objects may become haz ...
Oil Filter
Removal and Installation
WARNING:
Jacking up or lift up the vehicle may the vehicle height to go down which cause a personal injury and/or damage to the air suspension component parts. Refer to Precaution for when Jacking and Lifting Up the vehicle with Electronic Air Suspension System.
REMOVA ...
Rear Propeller Shaft
Exploded View
REMOVAL
Propeller shaft assembly
: vehicle front
: N·m (kg-m, ft-lb)
: Always replace after every disassembly.
DISASSEMBLY
Snap ring
Journal bearing
Journal
Flange yoke
Propeller shaft tube
: vehicle front
: Always r ...