Description
Initialization of system should be conducted after the following conditions. Refer to Work Procedure.
-
When the moonroof motor assembly or sunshade motor assembly is replaced.
-
When the moonroof or sunshade does not operate normally. (Incomplete initialization conditions)
Work Procedure
PERFORM SYSTEM INITIALIZATION
-
Close moonroof and sunshade.
-
Press and hold the moonroof switch CLOSE for approximately 10 seconds.
Moonroof and sunshade will move as following.
Moonroof tilt up, and the sunshade slightly close and stops.
-
Release the moonroof switch, and continue to press the moonroof switch CLOSE again soon.
Moonroof and sunshade will move as following.
Sunshade fully open → moonroof tilt down → moonroof fully open → moonroof fully closed → sunshade fully closed.
-
Release the moonroof switch after moonroof and sunshade stopped.
>>
GO TO 2.
CHECK THE FUNCTION
-
Check that moonroof and sunshade automatically operated normally.
-
Check anti-pinch function. Refer to Description.
>>
END
Other materials
Front Drive Shaft
Inspection
WARNING:
Jacking up or lift up the vehicle may the vehicle height to go down which cause a personal injury and/or damage to the air suspension component parts. Refer to Precaution for when Jacking and Lifting Up the vehicle with Electronic Air Suspension System.
FRONT DRIVE SHAFT IN ...
Diagnosis and Repair Work Flow
Work Flow
OVERALL SEQUENCEDETAILED FLOWGET INFORMATION FOR SYMPTOM
Get detailed information from the customer about the symptom (the condition and the environment when the incident/malfunction occurs).
Check operation condition of the function that is malfunctioning.
>>
GO TO 2.
CHECK ...
Front Pillar Finisher
Exploded View
Grommet
Front pillar finisher
Double-sided tape
[t: 2.5 mm (0.098 in)]
: Clip
: Always replace after every disassembly.
Removal and Installation
REMOVALFully open front door.
Apply a protective tape (A) on the parts to protect it from damage.
...