NIARMADA Nissan Armada manuals & owner information
Nissan Armada owner resource

Manuals, service information and practical owner guidance.

Fast access to Nissan Armada owner manuals, service procedures, maintenance references, technical information and practical guides for different Armada generations.

Browse manuals →
Nissan Armada manual library

Nissan Armada 2025-2026 Service and Repair Manual: Battery

Nissan Armada 2025-2026 Service and Repair Manual / Electrical & Power Control / Power Supply, Ground & Circuit Elements / Battery

Exploded View

Without ProPILOT ASSIST 2.1

Battery fix frame Battery cover Negative cable
Battery current sensor 12V battery Battery fix rod
Battery fix rod clip Battery tray Battery positive terminal
Battery positive terminal cover Battery terminal with fusible link Positive cable
: N·m (kg-m, in-lb)
: N·m (kg-m, ft-lb)
: vehicle front

With ProPILOT ASSIST 2.1

Battery fix frame Battery cover Negative cable
Battery current sensor 12V battery Battery fix rod
Battery fix rod clip Battery tray Battery positive terminal
Battery positive terminal cover Battery terminal with fusible link Positive cable
: N·m (kg-m, in-lb)
: N·m (kg-m, ft-lb)
: vehicle front

Removal and Installation

CAUTION:

  • When removing and installing 12V Battery, because of the heavy battery, please be careful about the working posture and use the ladder as required.

  • After the battery of a vehicle equipped with the Stop/Start System is replaced, the cumulative battery discharge current value stored in IPDM E/R must be erased, using CONSULT. Refer to Work Procedure.

NOTE:

The cumulative battery discharge current value is used for 12 V battery inspection.

If the cumulative value is not erased when replacing the battery, the accurate diagnoses cannot be made because it was added to the cumulative value before the battery replacement.

REMOVAL

Remove reservoir tank support bracket. Refer to RADIATOR : Removal & Installation.

Disconnect the 12V battery cable from the negative terminal.

CAUTION:

To prevent damage to the parts, disconnect the 12V battery cable from the negative terminal first.

Disconnect the 12V battery cable from the positive terminal.

Remove battery fix frame mounting nuts and battery fix frame .

Remove 12V battery.

Remove battery tray mounting bolts .

Remove battery tray.

INSTALLATION

Install in the reverse order of removal.

CAUTION:

To install the 12V battery, carefully read the following instructions.

  • To prevent damage to the parts, connect the 12V battery cable to the positive terminal first.

  • After connecting 12V battery cables, to securely supply 12V battery voltage, ensure that they are tightly clamped to 12V battery terminals for good contact.

  • To securely supply 12V battery voltage, check 12V battery terminal for poor connection caused by corrosion.

    Other materials

    How to enable/disable the I-BSI system
    Example ProPILOT Assist switch (design may vary depending on the Nissan Armada model) Vehicle information display Steering-wheel-mounted control (right side) To configure the Nissan Armada Intelligent Blind Spot Intervention (I-BSI) system, follow these steps: 1. Press the butt ...

    Off Road Models
    Exploded View Front bumper side bracket RH Front bumper side retainer RH Front bumper retainer upper Front bumper side stay RH Front bumper reinforcement Front bumper energy absorber A Front bumper energy absorber B RH Front bumper energy absorber C RH Front bumper energy a ...

    Washer Tank
    Exploded View Washer tank assembly Packing Hoodledge assembly RH Washer tank inlet Washer tank cap     : N·m (kg-m, in-lb) Removal and Installation WARNING: REMOVALCAUTION: When washer tank assembly is removed, washer fluid may come out so prepare a container to rece ...