When any of the following messages appear on the vehicle information display, a chime will sound and the I-BSI system will be turned off automatically.
- "Unavailable Slippery Road": When the VDC system (except traction control system function) or ABS operates.
- "Currently Unavailable due to Drive Mode or High Suspension Setting":
- When the VDC system is turned off.
- When the SNOW, SAND, ROCK or MUD/RUT mode is selected (if so equipped).
- "Driving Aids Limited Towing Assist Activated":
- When the trailer BSW is activated.
- When the TOW mode is selected (if so equipped).
- "Unavailable Camera Temperature High": If the vehicle is parked in direct sunlight under high temperature conditions (over approximately 104ºF (40ºC) ).
- "Unavailable Side Radar Obstruction": When side radar blockage is detected.
Turn off the I-BSI system and turn it on again when the above conditions no longer exist.
System malfunction
When the I-BSI system malfunctions, it will be turned off automatically, the I-BSI indicator illuminates and a chime will sound, and the "Malfunction See Owner's Manual" warning message will appear in the vehicle information display.
Action to take:
Stop the vehicle in a safe location and push the park button to engage the P (Park) position. Turn the engine off and restart the engine. If the warning message continues to appear, It is recommended you visit a NISSAN dealer for this service.
Other materials
Engine Control System
Symptom Table
SYSTEM — BASIC ENGINE CONTROL SYSTEM SYMPTOM Reference page
HARD/NO START/RESTART (EXCP. HA) ENGINE STALL HESITATION/SURGING/FLAT SPOT SPARK KNOCK/DETONATION LACK OF POWER/POOR ACCELERATION HIGH IDLE/LOW IDLE ROUGH IDLE/HUNTING IDLING VIBRATION SLOW/NO RETURN TO IDLE ...
Road Wheel Tire
Exploded View
Tire
Air valve
Wheel
: For non-reusable parts, refer to the TPMS configuration diagram.
Refer to TIRE PRESSURE SENSOR : Exploded View.
: N·m (kg-m, ft-lb)
Removal & Installation
WARNING:
Jacking up or lift up the vehicle may the vehicle height to go down which ...
Combination Switch System Symptoms
Symptom Table
Perform “Data Monitor” of CONSULT to check for any malfunctioning item.
Check that the data monitor display switches in conjunction with the combination switch operation.
If there is a switch whose display does not change, specify the applicable combination switch circuit (IN ...