Description
Wastegate valve closed position learning is a function of ECM to learn the fully closed position of the wastegate valve by monitoring the wastegate valve position sensor output signal. It must be performed under any of the following conditions.
Work Procedure
PERFORM WASTEGATE VALVE CLOSED POSITION LEARNING VALUE CLEAR
With CONSULT
-
On the CONSULT screen, select “ECM” >> “Work support” >> “WASTEGATE ACTUATOR POSI LEARN VALUE CLEAR”.
-
Touch “Start”.
-
Check that “COMPLETED” is displayed. If “COMPLETED” is not displayed, repeat the above.
>>
GO TO 2.
PERFORM NEW CLOSED POSITION LEARNING
With CONSULT
-
Check that the engine is cold [coolant temperature : 50 °C (122 °F) or less].
-
On CONSULT screen, select “ECM” >> “Data monitor” >> "Wastegate valve closed position learning bank 1" and "Wastegate valve closed position learning bank 2"
Check that “INCMP” is displayed.
-
Ignition switch OFF and wait at least 10 seconds.
-
Ignition switch ON and wait at least 10 seconds.
Is “CMPLT” displayed on CONSULT screen?
YES>>END
NO>>Check that the engine is cold [coolant temperature: 50 °C (122 °F) or less] And then, perform step 3 and 4 again.
Other materials
High Pressure Fuel Pump and Fuel Hose
Exploded View
CAUTION:
Never remove or disassemble parts unless instructed as shown in the figure.
High pressure fuel pump insulator
High pressure fuel pump
O-ring
High pressure fuel pump lifter
Bracket
Holder
Fuel feed hose
To fuel rail (bank 1). ...
Third Seat Belt Buckle
Removal and Installation
REMOVALSeat Belt Buckle LH and Connector BuckleRemove luggage floor board LH. Refer to Removal and Installation.
Disconnect harness connector.
Remove seat belt buckle LH and connector buckle mounting anchor bolt .
Pull out seat belt buckle LH and connector buckle from thir ...
Anti-Pinch Inspection
Description
Check anti-pinch function when the initialization of moonroof and sunshade system is performed. Refer to Work Procedure.
Work Procedure
CHECK ANTI-PINCH FUNCTION
Fully open the moonroof.
Place a piece of wood near the fully closed position.
Close the moonroof completely with auto c ...