If any of the following operations are performed, the initialization is necessary for normal operation of power window system. Refer to Work Procedure.
When each power window motor replaced.
Power supply to the each power window motor is not cut off properly.
Removal and installation of regulator assembly.
Removal and installation of each power window motor from regulator assembly.
Operation of regulator assembly as an independent unit.
Removal and installation of door glass.
Removal and installation of door glass run.
CAUTION:
The following specified operations cannot be performed under the non-initialized condition.
Auto-up operation
Anti-pinch function
Work Procedure
Work ProcedureRemoval and Installation
REMOVAL
CAUTION:
Before removing, take a short memo/photo to remember door harness and cable layout.
Remove front door glass. Refer to Removal and Installation.
Disconnect harness connectors , and then disengage harnesses fixing clips.
: Clip
Remove hole seals from front door panel, and then r ...
MULTI-WAY CONTROL VALVE : Exploded View
Multi-way control valve O-ring Water outlet Engine coolant temperature sensor 1 Gasket To oil cooler hose 1. Refer to Exploded View. To electric water pump. Refer to Exploded View. To radiator. Refer to RADIATOR : Exploded View. To electric throttle control actuator. Refer to Exploded View ...
Exploded View
Front cover Dowel pin Oil pressure sensor Oil temperature sensor Crankshaft pulley bolt Crankshaft pulley Front oil seal O-ring(oil line) O-ring(water line) Comply with the installation procedure when tightening. Refer to Removal & Installation. : N·m (kg-m, ft-lb) : Always replac ...