Description
Throttle Valve Closed Position Learning is a function of ECM to learn the fully closed position of the throttle valve by monitoring the throttle position sensor output signal. It must be performed each time harness connector of electric throttle control actuator or ECM is disconnected or electric throttle control actuator is cleaned. (For details, refer to Work Procedure .)
Work Procedure
START
With CONSULT
-
Ignition switch ON.
-
On CONSULT screen, select “ECM”>>“Work support”>>“Close throttle position learning”.
-
Follow the instructions on the CONSULT display.
-
Ignition switch OFF and wait at least 10 seconds.
-
Check that throttle valve moves during the above 10 seconds by confirming the operating sound.
Without CONSULT
-
Start the engine.
NOTE:
Coolant temperature is less than 25°C (77°F) before engine starts.
-
Warm up the engine until engine coolant temperature reaches 65°C (149°F).
-
Ignition switch OFF and wait at least 10 seconds.
-
Check that throttle valve moves during the above 10 seconds by confirming the operating sound.
>>
END
Other materials
MOD system limitations
WARNING
The following section outlines important limitations of the Moving Object
Detection (MOD) system in the Nissan Armada. Ignoring these limitations or relying
on the system beyond its capabilities may significantly increase the risk of accidents,
serious injury, or even fatal outcomes. ...
Basic information
The Nissan Armada driving recorder system is designed to capture high-quality
video and photo footage from both the front and rear of the vehicle, providing an
additional layer of safety, documentation, and convenience. All recorded content
can be easily accessed and reviewed directly on the N ...
Additional Service When Replacing Around View Monitor Control Unit
Description
CAUTION:
When replacing the around view monitor control unit, always replace it with a new one. Around view monitor system does not operate properly in case of reuse of the around view monitor control unit from another vehicle.
When before writing the around view monitor control unit ...