Exploded View
 |
Transfer assembly | ||||
 |
: N·m (kg-m, ft-lb) |
Removal and Installation
WARNING:
-
Jacking up or lift up the vehicle may the vehicle height to go down which cause a personal injury and/or damage to the air suspension component parts. Refer to Precaution for when Jacking and Lifting Up the vehicle with Electronic Air Suspension System.
REMOVAL
Disconnect negative battery terminal. Refer to Removal and Installation.
Remove rear propeller shaft. Refer to Removal and Installation .
Remove front propeller shaft. Refer to Removal and Installation.
Disconnect transfer control actuator and transfer range position sensor harness connectors and separate harnesses from transfer assembly.
Disconnect transfer cam position sensor harness connectors and separate harnesses from transfer assembly.
Remove transfer breather hose. Refer to Removal and Installation.
Remove main muffler. Refer to EXHAUST SYSTEM : Removal & Installation.
Support transfer assembly and transmission assembly with a jack.
CAUTION:
Secure transfer assembly and transmission assembly to a jack.
Remove rear engine mounting cross member. Refer to Removal and Installation.
Lower jack to the position where the top transfer mounting bolts can be removed.
Remove transfer mounting bolts and separate transfer from transmission.
CAUTION:
Secure transfer assembly and transmission assembly to a jack.
INSTALLATION
Install in the reverse order of removal.
Inspection and Adjustment
INSPECTION AFTER INSTALLATION
Check fluid leakage and the fluid level. Refer to Inspection.
ADJUSTMENT AFTER INSTALLATION
When replacing transfer assembly, performe writing unit parameter. Refer to Description.
Other materials
Steering Wheel Turning Force Is Heavy or Light
Description
Steering wheel turning force is heavy or light.
Diagnosis Procedure
PERFORM SELF-DIAGNOSIS
With CONSULT
Pull the parking brake switch.
NOTE:
Check to make sure that the parking brake switch indicator is turned ON.
Ignition switch OFF.
Get out of the vehicle and close all doors.
W ...
Additional Service When Replacing A/c Auto Amp.
Description
After replaced A/C auto amp. it is necessary to perform control unit configuration with CONSULT. For details, refer to Work Procedure.AFTER REPLACEMENTCAUTION:
When replacing A/C auto amp. write vehicle specification with CONSULT vehicle configuration.
Never perform vehicle configura ...
Precautions
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"
The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger fo ...