Exploded View
 |
Transfer assembly |  |
Air breather hose A |  |
Clip A |
 |
Hose connector |  |
Clip B |  |
Air breather hose B |
 |
Clip C |  |
Air breather | ||
 |
: Always replace after every disassembly. | ||||
Removal and Installation
WARNING:
-
Jacking up or lift up the vehicle may the vehicle height to go down which cause a personal injury and/or damage to the air suspension component parts. Refer to Precaution for when Jacking and Lifting Up the vehicle with Electronic Air Suspension System.
REMOVAL
Remove air breather hose A from transfer assembly.
Remove clip A .
Remove clip B .
Remove A/T air breather hose. Refer to Removal and Installation.
Release clip C and remove air breather hose assembly 
from bracket.
Separate each component part.
INSTALLATION
Note the following, and install in the reverse order of removal.
-
For non-reusable parts, refer to Exploded View.
-
Align rib
of the air breather with the paint mark 
on the air breather hose, and install air breather hose so that the paint mark faced backward of the vehicle.
: vehicle front -
Install air breather hose A with the paint mark
facing leftward.
: vehicle front -
Be sure to insert air breather hose to air breather tube until hose end reaches the end of tube.
-
When inserting air breather hose A and air breather hose B to hose connector
, be sure to insert it fully until its reaches the stop.
CAUTION:
Install each air breather hose with the painted mark
facing towards the top of the vehicle.
Other materials
Basic information
Example
The vehicle information display in the Nissan Armada is centrally positioned
within the instrument cluster and serves as a key interface for driver information
and system notifications. It provides real-time data and customizable settings for
enhanced driving awareness.
The Nissa ...
Transfer: Atx93b Tools and Preparation
Preparation
Commercial Service Tools
Tool name Description
Drift
a: 61.0 mm (2.402 in) dia.
b: 56.3 mm (2.217 in) dia.
Installing front oil seal
Drift
a: 66.3 mm (2.610 in) dia.
b: 61.9 mm (2.437 in) dia.
Installing rear oil seal
Drift
a: 68.6 mm (2.701 in) dia.
b: 58.0 mm (2.28 ...
Front Seatback
Disassembly and Assembly
WARNING:
When working, be careful to prevent accidental explosion front side air bag module and front center air bag module (with front center air bag module). Refer to Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER".CAUTION:
When d ...