Nissan Armada 2025-2026 Service and Repair Manual: Ultra High Strength Steel Part
DESCRIPTION
Ultra high strength steel parts signify high strength steel plates with tensile strength of 980 MPa or more.
When replacing parts made of ultra high strength steel or parts including ultra high strength steel, never perform the prohibition described below:
PROHIBITION
WARNING:
Never cut ultra high strength steel parts or perform butt welding. Violation of this prohibition causes extreme strength degradation, and the strength before damage cannot be secured.
PART REPLACEMENT
To replace an ultra high strength part, be sure to replace it by panel supply unit of ultra high strength steel part.
For the welding method, refer to Welding of Ultra High Strength Steel.
Underbody Component Parts
ENGINE COMPARTMENT
Refer to parts catalogue for the replacement parts.
Figure from the indoor side : Vehicle front
: Both sided anti-corrosive precoated steel sections
: High strength steel (HSS) se ...
Other materials:
Work Flow
OVERALL SEQUENCE
DETAILED FLOW
INTERVIEW FOR MALFUNCTION
NOTE:
>>
GO TO 2.
SELF-DIAGNOSIS WITH CONSULT
With CONSULT
Perform self-diagnosis of ”SONAR” using CONSULT. Refer to CONSULT Function.
NOTE:
Skip to step 4 of the diagnosis procedure if “SONAR” is not displayed.
Is any DTC de ...
Exploded View
Body side outer panel Side window glass Glass primer Adhesive Edge Adhesive mark : Clip : Always replace after every disassembly.
Unit: mm (in)
Portion Primer range Adhesive range L N Side window glass - Body side outer panel - F From edge, more than 20.0
(0.79) 7.0 + 2.0, - 0.0
(0. ...
Removal and Installation
WARNING:
REMOVAL
Drain gear oil. Refer to Draining.
Remove rear propeller shaft from final drive. Refer to Removal and Installation.
Remove drive shafts. Refer to Removal and Installation.
Remove rear supension member stay. Refer to Removal and Installation.
Remove breather hose from rear final dri ...
0.0096