Description
A malfunction of brake pedal feel (height or others) is detected when brake pedal is depressed.
Diagnosis Procedure
CHECK FRONT AXLE AND REAR AXLE
-
Disconnect 12V battery negative terminal.
-
Check that there is no excessive looseness in front and rear axle.
-
Front axle
-
2WD models: Refer to Inspection.
-
4WD models: Refer to Inspection.
-
-
Rear axle: Refer to Inspection.
-
Is the inspection result normal?
YES>>GO TO 2.
NO>>Repair or replace error-detected parts.
CHECK DISC ROTOR
Check the disc rotor.
-
Front: Refer to Inspection and Adjustment.
-
Rear: Refer to Inspection and Adjustment.
Is the inspection result normal?
YES>>GO TO 3.
NO>>Refinish or replace the disc rotor.
CHECK BRAKE FLUID LEAKAGE
Check the fluid leakage.
-
Front: Refer to Inspection.
-
Rear: Refer to Inspection.
Is the inspection result normal?
YES>>GO TO 4.
NO>>Repair or replace error-detected parts.
CHECK BRAKE PEDAL
Check the brake pedal.
- Brake pedal height: Refer to Inspection and Adjustment.
- Brake pedal assembly: Refer to Inspection.
Is the inspection result normal?
YES>>GO TO 5.
NO>>Adjust the brake pedal height or replace brake pedal assembly.
- Adjust the brake pedal: Refer to Inspection and Adjustment.
- Replace the brake pedal: Refer to Removal and Installation.
CHECK BRAKING FORCE
Check the brake force using a brake tester.
Is the inspection result normal?
YES>>GO TO 6.
NO>>Check each components of brake system.
CHECK BRAKE PERFORMANCE
-
Disconnect the ABS actuator and electric unit (control unit) connector so that ABS does not operate.
-
Check that brake force is normal in this condition. Connect harness connectors after checking.
Is the inspection result normal?
YES>>Normal
NO>>Check each components of brake system.
Other materials
RAB system limitations
WARNING
The following limitations apply to the Rear Automatic Braking (RAB) system
in the Nissan Armada. Failure to fully understand and follow these limitations may
result in serious injury or even fatal accidents.
When the Nissan Armada approaches an obstacle while the accelerator or
b ...
Adjustment of Steering Angle Sensor Neutral Position
Description
Always adjust the neutral position of steering angle sensor before driving when the following operation is performed. Refer to Work Procedure.×: Required —: Not required Procedure Adjust the neutral position of steering angle sensor
Removing/ installing ABS actuator and electric un ...
Exhaust Gas/outside Odor Detecting Sensor
Exploded View
Exhaust gas/outside odor detecting sensor
Active grille shutter
: Clip
: Pawl
: vehicle front
Removal and Installation
REMOVALRemove front grille upper. Refer to the following.
Off road models: Removal and Installation
City models: Removal and Insta ...