Description
After working the following, transfer unit parameter must be written to transfer control unit.
-
Transfer control unit replacing
-
Transfer assembly replacing
-
Transfer control actuator replacing
-
Transfer range position sensor replacing
-
Transfer case component parts disassembling
NOTE:
Write charactereistic value in transfre control unit, if the above each parts is replaced.
For the work procedure, refer to Work Procedure.
Work Procedure
WARNING:
-
Jacking up or lift up the vehicle may the vehicle height to go down which cause a personal injury and/or damage to the air suspension component parts. Refer to Precaution for when Jacking and Lifting Up the vehicle with Electronic Air Suspension System.
UNIT CHARACTERISTIC VALUE CONFIRMATION
Confirm the 5-digit alphanumeric unit characteristic value written in the QR code pasted on the side or top of the transfer assembly.

![]() |
: Side surface |
![]() |
: Top surface |
NOTE:
There is space on the top to check with the camera.
>>
GO TO 2.
WRITING UNIT PARAMETER
With CONSULT
-
Ignition switch ON.
-
Select “Work support� in “AWD/4WD�.
-
Perform “Unit parameter writing� to the CONSULT display.
>>
WORK END
Other materials
Reporting safety defects
For USA
If you believe your Nissan Armada has a defect that could lead to a crash, injury,
or even death, it is essential to report the issue immediately.
You should notify both the National Highway Traffic Safety Administration (NHTSA)
and NISSAN to ensure that the concern is properly documen ...
Door Does Not Lock/unlock and Engine Does Not Start (all I-Key/req Sw/push Sw)
Description
All doors do not lock/unlock using door request switch and engine does not start when push-button ignition switch is pressed while carrying Intelligent Key.SYMPTOM TABLE (BOTH INTELLIGENT KEYS HAVE THE SAME SYMPTOMS) Door lock operation (remote keyless entry) Door lock operation (one to ...
Recommended Fluids and Lubricans
Fluids and Lubricants
Recommended Fluid and LubricantsThe following are approximate capacities. The actual refill capacities may be slightly different. When refilling, follow the procedures described elsewhere in this manual. Fluid type Capacity (approximate) Recommended Fluids/Lubricants
Metric ...

