- Precautions
- Transfer: Atx93a Tools and Preparation
- Diagnosis and Repair Work Flow
- Additional Service When Replacing Transfer Control Unit
- Unit Parameter Writing
- Heavy Tight-Corner Braking Symptom Occurs
- 4wd Mode Does Not Change
- Noise, Vibration and Harshness (nvh) Troubleshooting
- Transfer Fluid
- Transfer Control Unit
- 4wd Shift Switch
- Front Oil Seal
- Rear Oil Seal
- Input Oil Seal
- Transfer Control Actuator
- Transfer Range Position Sensor
- Air Breather
- Transfer Assembly
Other materials
Diagnosis and Repair Workflow
Work Flow
OVERALL SEQUENCEDETAILED FLOWINTERVIEW FOR MALFUNCTION
Interview the symptom to the customer.
>>
GO TO 2.
SYMPTOM CHECK
Check the symptom from the customer's information. Check that any symptom occurs other than the interviewed symptom.
Insufficient cooling/heating>>
GO TO ...
Calibration of Automatic Back Door Position Information
Description
When the following work is performed, it is necessary to perform initial setting of automatic back door position information to operate automatic back door system. Refer to Work Procedure.
After removing and installing, or replacing back door assembly
After removing and installing, or ...
Additional Service When Replacing Driving Video Recorder Control Module
Work Procedure
DRIVING VIDEO RECORDER CONTROL MODULE REPLACEMENT
Replace driving video recorder control module. Refer to Removal and Installation.
>>
GO TO 2.
WRITING OF VIN DATA TO DRIVING VIDEO RECORDER CONTROL MODULE
With CONSULT
Ignition switch ON and wait at least 5 seconds.
Select ...