Nissan Armada 2025-2026 Service and Repair Manual: With Propilot Assist 2.1

Work Procedure

Always perform the additional service after replacing the ADAS control unit 2. ADAS CONTROL UNIT 2 CONFIGURATION Perform saving vehicle internal information according to "Replace ECU" in CONSULT Opera ...

Work Procedure

ADAS CONTROL UNIT 2 CONFIGURATION >> GO TO 2. VIN REGISTRATION Turn ignition switch OFF. Turn ignition switch ON. NOTE: If ignition switch is not turned OFF after setting configuration, ADAS ...

Other materials:

Removal and Installation
REMOVAL Remove the back door finisher. Refer to Removal and Installation. Remove the rear camera mounting screws , then remove the rear camera . INSTALLATION Install in the reverse order of removal. Perform parameter writing. (With ProPILOT Assist 2.1) Refer to Work Procedure. Perform camera imag ...

TIRE PRESSURE SENSOR : Removal & Installation
WARNING: REMOVAL Remove tire assembly. Refer to ROAD WHEEL TIRE : Removal & Installation. Remove valve cap, valve core and then deflate tire. NOTE: If the tire is reused, apply a matching mark to the position of the tire road wheel valve hole for the purpose of wheel balance adjustment after in ...

Removal and Installation
WARNING: REMOVAL Remove the following parts: Front under cover using a power tool (commercial service tool). Refer to Removal and Installation. Drive belt: Refer to Removal & Installation. Crankshaft pulley: Refer to Removal & Installation. Remove front oil seal using a suitable tool. CA ...