DETAILED FLOW
INTERVIEW FROM THE CUSTOMER
Clarify customer complaints before inspection. First of all, perform an interview utilizing reproduce symptoms as well as fully understand it. Ask customer about his/her complaints carefully. Check symptoms by driving vehicle with customer, if necessary. Refer to Diagnostic Work Sheet.
CAUTION:
>>GO TO 2.
CHECK SYMPTOM
Reproduce the symptom that is indicated by the customer, based on the information from the customer obtained by interview. Also check that the symptom is not caused by protection function. Refer to Protection Function.
CAUTION:
>>GO TO 3.
PERFORM SELF-DIAGNOSIS
With CONSULT
Perform self-diagnosis.
Is any DTC detected?
YES>>Record or print DTC. GO TO 4.
NO>>GO TO 6.
RECHECK SYMPTOM
With CONSULT
Erase self diagnosis result for "EPS/DIRECT ADAPTIVE STEERING 3".
Pull the parking brake switch.
NOTE:
Check to make sure that the parking brake switch indicator is turned ON.
Ignition switch OFF.
Get out of the vehicle and close all doors.
Wait 65 seconds.
NOTE:
Check to make sure that the parking brake switch indicator is turned OFF.
If the rear brake calipers are hot, wait up to an hour until parking brake switch indicator turns OFF. Once parking brake switch indicator turns OFF, move to next step.
Start the engine.
CAUTION:
Never drive the vehicle.
Perform DTC confirmation procedures for the error detected system.
NOTE:
If some DTCs are detected at the same time, determine the order for performing the diagnosis based on. Refer to DTC Inspection Priority Chart.
Is any DTC detected?
YES>>GO TO 5.
NO >>REPAIR OR REPLACE ERROR-DETECTED PARTS
Repair or replace error-detected parts.
Reconnect part or connector after repairing or replacing.
When DTC is detected, erase self diagnosis result for "EPS/DIRECT ADAPTIVE STEERING 3".
GO TO 7.
IDENTIFY ERROR-DETECTED SYSTEM BY SYMPTOM DIAGNOSIS
Can the error-detected system be identified?
YES>>GO TO 7.
NO >>FINAL CHECK
With CONSULT
Check the reference value for power steering control module.
Is the symptom reproduced?
YES>>GO TO 3.
NO>>INSPECTION END
Diagnostic Work SheetAdjustment
WIPER BLADE POSITION ADJUSTMENT
Adjust clearance between the end of cowl top cover/front fender cover RH and the top of front wiper blade center.
Windshield glass Front wiper blade RH Front wiper blade LH Front fender cover RHCowl top cover
Standard clearance C : 20.8 ± 7.5 mm (0.82 ± 0 ...
Removal and Installation
CAUTION:
REMOVAL
Remove driver knee air bag module mounting bolts, and then move driver knee air bag module to secure workspace. Refer to Removal and Installation.
Disconnect harness connector.
Remove fixing clip , and then remove front foot lamp bracket (LH).
Disengage front foot lamp (LH) fixing ...
How to enable/disable the TSR system
Vehicle information display
Steering-wheel-mounted controls (right side)
To configure the Nissan Armada TSR system, follow these steps:
1. Press the
button until "Settings" appears on the vehicle information display. Then press the
scroll dial.
2. Navigate to "Driv ...