Nissan Armada 2025-2026 Service and Repair Manual: Basic Inspection
- Diagnosis and Repair Work Flow
- Work Flow
- Diagnostic Work Sheet
- Basic Inspection
- Work Procedure
- Service After Replacing or Removing Engine Parts
- Additional Service When Replacing Ecm
- Work Procedure
- Vin Registration
- Work Procedure
- Accelerator Pedal Released Position Learning
- Work Procedure
- Electric Ivt Control Actuator Position Learning
- Work Procedure
- Throttle Valve Closed Position Learning
- Work Procedure
- Wastegate Valve Closed Position Learning
- Work Procedure
- Idle Air Volume Learning
- Work Procedure
- Mixture Ratio Self-Learning Value Clear
- Work Procedure
- Mac Key Writing
- Work Procedure
- Engine Oil Data Reset
- Work Procedure
- Fuel Pressure Check
- Work Procedure
- How to Set Srt Code
- SRT Set Driving Pattern
- Work Procedure
- How to Erase Permanent Dtc
- Work Procedure (Group A)
- Work Procedure (Group B)
Wiring Diagram
Click link to Wiring Diagram. ...
Other materials:
Removal and Installation
REMOVAL
Remove the back door finisher. Refer to Removal and Installation.
Remove the rear camera mounting screws , then remove the rear camera .
INSTALLATION
Install in the reverse order of removal.
Perform parameter writing. (With ProPILOT Assist 2.1) Refer to Work Procedure.
Perform camera imag ...
Welding of Ultra High Strength Steel
SPOT WELDING
Spot welding is limited to ultra high strength steel (tensile strength: 980 MPa) according to the welding conditions listed below.
CAUTION:
If the below welding conditions cannot be met, then perform plug welding.
Never spot weld ultra high strength steel of tensile strength more than 9 ...
Diagnosis Procedure
CHECK AUTO OPEN/CLOSE FUNCTION
Check auto open/close function using back door opener switch operation.
Is the inspection result normal?
YES>>
GO TO 2.
NO>>
Refer to Diagnosis Procedure.
CHECK AUTOMATIC BACK DOOR SWITCH
Check automatic back door switch.
Refer to Component Function Check ...
0.006