START
With CONSULT
Start engine and warm it up to normal operating temperature.
On CONSULT screen, select “ECM”>>“Work support”>>“Air fuel ratio learning value clear”.
Clear mixture ratio self-learning value by touching “CLEAR”.
With GST
Start engine and warm it up to normal operating temperature.
Ignition switch OFF.
Disconnect mass air flow sensor (bank 1) harness connector.
Restart engine and let it idle for at least 5 seconds.
Stop engine and reconnect mass air flow sensor (bank 1) harness connector.
Select Service $03 with GST. Make sure DTC P0102 is detected.
Select Service $04 with GST to erase the DTC P0102.
END
Mixture Ratio Self-Learning Value Clear
Mac Key WritingUnderbody
WARNING:
MEASUREMENT (CABIN)
Bottom view
The following figure shows a bottom view of the vehicle.
Unit: mm (in)
: Vehicle front
: Vehicle left side
Unit: mm (in)
«The others» Point Dimension Memo Point Dimension Memo Point Dimension Memo – 1102 (43.39) – 1253 (49.33) – 1702 (67 ...
Work Flow
OVERALL SEQUENCE
DETAILED FLOW
GET INFORMATION FOR SYMPTOM
Check operation condition of the function that is malfunctioning.
>>
GO TO 2.
CHECK DTC
Check DTC.
Perform the following procedure if DTC is detected.
Record DTC (Print them out using CONSULT).
Erase DTC.
Are any symptoms describ ...
Settings
Basic information
The Settings mode in the Nissan Armada provides drivers with a comprehensive
interface for customizing both the vehicle information display and various system
configurations. Through this menu, users can tailor the Nissan Armada driving experience
according to personal prefe ...