Nissan Armada 2025-2026 Service and Repair Manual: Work Procedure
WRITING VEHICLE SPECIFICATION
With CONSULT
Perform writing vehicle specification to air bag diagnosis sensor unit according to "Replace ECU" in "CONSULT Operation Manual".
>>GO TO 2
CHECK ALL ECU SELF-DIAGNOSIS RESULTS
With CONSULT
Erase all ECU self-diagnosis results using CONSULT.
Ignition switch OFF.
Ignition switch ON.
Check that all ECU self-diagnosis results have no DTC.
WORK END
Configuration (air Bag Diagnosis Sensor Unit)
Vehicle specification needs to be written with CONSULT because it is not written after replacing the air bag diagnosis sensor unit.
CONSULT connects to network and then it downloads the configuration ...
Additional Service When Replacing Occupant Detection System Control Unit
When replacing occupant detection system control unit or removing and installing passenger seat, always perform zero point reset so that occupant detection system is activated normally. Refer to Work ...
Other materials:
Precautions for Removing Battery Terminal
NOTE:
NOTE:
NOTE:
The removal of 12V battery may cause a DTC detection error.
HOW TO DISCONNECT 12V BATTERY TERMINAL
Disconnect 12V battery terminal according to instruction described below.
Open the hood.
Turn ignition switch to the ON position.
Turn ignition switch to the OFF position with the d ...
Work Flow
OVERALL SEQUENCE
DETAILED FLOW
INTERVIEW FOR MALFUNCTION
It is also important to clarify the customer concerns before starting the inspection. Interview the customer about the concerns carefully and understand the symptoms fully.
NOTE:
The customers are not professionals. Never assume that “mayb ...
Service Notice or Precautions for Transfer
Use recommended transfer oil only. Refer toFluids and Lubricants.
Never reuse transfer fluid, once it has been drained.
Check the fluid level or replace the fluid only with the vehicle parked on level ground.
During removal or installation, keep inside of transfer clear of dust or dirt.
Replace all ...
0.0053