Description
Accelerator Pedal Released Position Learning is a function of ECM to learn the fully released position of the accelerator pedal by monitoring the accelerator pedal position sensor output signal. It must be performed each time the harness connector of the accelerator pedal position sensor or ECM is disconnected. (For details, refer to Work Procedure .)
Work Procedure
START
-
Make sure that accelerator pedal is fully released.
-
Ignition switch ON and wait at least 2 seconds.
-
Ignition switch OFF and wait at least 10 seconds.
-
Ignition switch ON and wait at least 2 seconds.
-
Ignition switch OFF and wait at least 10 seconds.
>>
END
Other materials
Front Suspension Tools and Preparation
Special Service Tools
The actual shapes of TechMate tools may differ from those of special service tools illustrated here.
Tool number
(TechMate No.)
Tool name Description
ST35652000
( − )
Shock absorber attachment
Disassembling and assembling shock absorber
ST3127S000
(NI-25765-A) ...
Normal Operating Condition
Symptom Description
SYSTEM UNITLIQUID CRYSTAL DISPLAY Symptom Possible cause Possible solution
The screen is too dark.
The cabin temperature is too low.
Wait until the cabin temperature becomes moderate.
The cabin temperature is too hot.
Screen brightness is set to the maximum darkness ...
Chassis Control
Symptom Table
INTELLIGENT TRACE CONTROLPerform self-diagnosis using CONSULT before the symptom diagnosis. Perform trouble diagnosis if any DTC is detected. Refer to DTC Index. Symptom Possible cause Inspection item
Intelligent trace control inoperative/ineffective
No intelligent trace control ...