Work Procedure
Description
When AV control unit is replaced, AV control unit configuration is required.
REPLACE AV CONTROL UNIT
Replace AV control unit. Refer to Removal & Installation.
>>
GO TO 2
PERFORM AV CONTROL UNIT PROGRAMMING & CONFIGURATION
CONSULT
Perform AV control unit programming, according to “Replace ECU” of CONSULT Operation Manual. Refer to CONSULT Operation Manual.
CAUTION:
During programming, maintain the following conditions:
-
Ignition switch: ON
-
Electric load: OFF
-
Brake pedal: Not depressed
-
12V battery voltage: 12 – 13.5 V (Check the value displayed on the CONSULT screen.)
>>
GO TO 3
WRITE VIN DATA (AV CONTROL UNIT)
CONSULT work support
Perform “WRITE VIN (MANUAL INPUT)” to write VIN data.
>>
GO TO 4
CHECK NETWORK INITIAL SETTINGS
CONSULT Work Support
Select “Work Support” of “MULTI AV” and perform “Network initial settings”.
>>
WORK END
Other materials
Basic information
WARNING
In the Nissan Armada, radio frequency signals emitted by the Intelligent
Key system may interfere with certain medical devices.
Individuals using pacemakers or similar medical equipment should consult
the device manufacturer to determine possible effects before using the Nissa ...
Air Breather
Exploded View
Transfer assembly
Air breather hose A
Clip A
Hose connector
Clip B
Air breather hose B
Clip C
Air breather
: Always replace after every disassembly.
Removal and Installation
WARNING:
Jacking up or lift up the vehicle may the vehicle hei ...
Headlining
Exploded View
Without Moonroof Models
Roof rear garnish
Room lamp bracket
Headlining assembly
Third assist grip RH
Personal lamp bracket
Personal lamp
Second assist grip RH
Vanity mirror lamp bracket
Front assist grip RH
Vanity mirror lamp
Map lamp bracket
Sun v ...