Description
Vehicle specification needs to be written with CONSULT because it is not written after replacing the chassis control module. For details the operation, refer to “CONSULT Operation Manual”.
Work Procedure [After Replacing Chassis Control Module]
WRITING VEHICLE SPECIFICATION
With CONSULT
Perform writing vehicle specification to chassis control module according to "Replace ECU" in CONSULT Operation Manual.
>>
GO TO 2.
PERFORM NECESSARY WORK
With CONSULT
-
Perform configuration. Refer to Work Procedure.
-
Perform MAC key writing. Refer to Work Procedure.
-
Perform self-diagnosis for “CHASSIS CONTROL”.
-
Erase the memory of self-diagnosis results.
>>
WORK END
Other materials
Parking/parking on hills
WARNING
Do not park or stop your Nissan Armada over combustible materials such
as dry grass, paper, or cloth.
These materials may ignite due to heat from the exhaust system and cause
a fire hazard.
Never leave the Nissan Armada engine running while the vehicle is unattended, ...
Front Oil Seal
Removal and Installation
WARNING:
Jacking up or lift up the vehicle may the vehicle height to go down which cause a personal injury and/or damage to the air suspension component parts. Refer to Precaution for when Jacking and Lifting Up the vehicle with Electronic Air Suspension System.
REMOVA ...
Memory Storing
Description
Always perform the memory storage when the driver seat control unit or steering column control module is replaced. The memory function will not operate normally if no memory storage is performed. For details, refer to Work Procedure.
Work Procedure
Memory Storage ProcedureTwo positions f ...