Work Procedure
When driver monitor camera control unit is replaced, be sure to perform the specified incidental work in order to operate system normally.
DRIVER MONOTOR CAMERA CONTROL UNIT CONFIGURATION
Perform saving vehicle internal information according to "Replace ECU" in CONSULT Operation Manual.
>>
GO TO 2.
CHECK DATA MONITOR
Check that "Face" is "within range" in "Data monitor" of "Driver Monitor Camera".
Is the inspection result normal?
YES>>GO TO 3.
NO>>Check installation status of the driver monitor camera control unit (installation position, specified tightening torque, bending of bracket, etc.).
PERFORM SELF-DIAGNOSIS
Check that DTC is detected in self-diagnosis result of "Driver Monitor Camera".
Is DTC detected?
YES>>Perform a diagnosis of detected DTC and repair or replace the malfunction parts. Refer to DTC Index.
NO>>WORK END
Other materials
Glass & Window System Tools and Preparation
Special Service Tools
The actual shapes of TechMate tools may differ from those of special service tools illustrated here.
Tool number
(TechMate No.)
Tool name Description
(NI-39570)
Chassis ear
Locates the noise
(NI-50397)
NISSAN Squeak and Rattle Kit
Repairs the cause of noise
C ...
Precautions
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"
The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger fo ...
Steering Torque Calibration
Work Procedure
After replacing the ADAS control unit 2 and after replacing or removing the following steering components, the steering torque calibration is necessary to operate the system normally.
Steering wheel
Spiral cable
Steering angle sensor
Steering column assembly
Steering gear ass ...