WARNING
Improper loading or exceeding the recommended trailer capacity for your Nissan Armada can significantly affect handling, braking efficiency, and overall performance, potentially leading to dangerous driving conditions or accidents.
CAUTION
- Avoid towing a trailer or carrying heavy loads with your Nissan Armada until it has been driven at least 500 miles (800 km). This initial break-in period is essential to prevent premature wear or damage to the engine, drivetrain, and axle components.
- During the first 500 miles (800 km) of towing, do not exceed speeds of 50 MPH (80 km/h), and avoid rapid acceleration or full-throttle starts. This helps critical components of your Nissan Armada properly adapt to increased load conditions.
- Using premium gasoline with a minimum rating of 91 AKI (Research Octane
Number 96) is highly recommended when towing with your Nissan Armada to maintain
optimal engine performance.
If lower-grade fuel is used—especially in hot weather, on steep inclines, or while towing heavy loads—engine temperature may rise, and power output may decrease due to engine protection systems activating. In such situations, avoid aggressive acceleration to protect your Nissan Armada.
Your Nissan Armada is primarily designed for transporting passengers and cargo, but it is also capable of towing when properly equipped. Keep in mind that towing adds extra stress to the engine, transmission, steering, braking, and suspension systems.
For detailed towing guidelines, refer to the official NISSAN Towing Guide (U.S. only), available at www.nissanusa.com. This resource provides comprehensive information about towing capacities and required equipment for safe trailer operation with your Nissan Armada.
Other materials
4wd Tools and Preparation
Preparation
Special Service Tool
Tool number
(TechMate No.)
Tool name Description
KV40104001
(NI-53385)
Hub lock nut wrench
a: 85 mm (3.35 in)
b: 65 mm (2.56 in)
Removing and Installing wheel hub lock nut.
KV40107300
(NI-51751)
Boot band crimping tool
Installing boot band
KV401 ...
Noise, Vibration and Harshness (nvh) Troubleshooting
NVH Troubleshooting Chart
Use chart below you find the cause of the symptom. If necessary, repair or replace these parts. Possible cause and SUSPECTED PARTS Symptom Reference
DRIVE SHAFT REAR AXLE
Noise Shake Noise Shake Vibration Shimmy Judder Poor quality ride or
Excessive joint an ...
Front Fender
Exploded View
Hood side seal
Front fender drip cover
Front fender bracket
Front fender assembly
Front fender protector tape
Front fender duct
Front fender baffle
Fender cover LH
Fender cover RH
Double-sided tape [t: 0.8 mm (0.031 in)]
: C ...