Nissan Armada owner resource

Manuals, service information and practical owner guidance.

Fast access to Nissan Armada manuals, operating instructions, maintenance references and technical information.

Browse manuals
Nissan Armada manual library

Nissan Armada 2025-2026 Service and Repair Manual: Configuration

Description

Vehicle specification needs to be written with CONSULT because it is not written after replacing the ABS actuator and electric unit (control unit).

The configuration requires network connection. CONSULT connects to network and then it downloads the configuration data from the server. Then CONSULT writes the vehicle specification to the ABS actuator and electric unit (control unit).

Refer to Work Procedure.

NOTE:

For details the network connection and operation, refer to “CONSULT Operation Manual”.

The configuration no need to “save” configuration data from the ABS actuator and electric unit (control unit). The configuration data is always generated freshly at the server and then downloaded to the CONSULT.

CAUTION:

  • Complete the procedure of “Configuration” in order.

  • If incorrect “Configuration”, incidents might occur.

  • Never perform “Configuration” except for new ABS actuator and electric unit (control unit).

Work Procedure

WRITING VEHICLE SPECIFICATION

With CONSULT

Perform writing vehicle specification to ABS actuator and electric unit (control unit) following "Automatic Configuration" procedure of "Configuration" according to CONSULT Operation Manual.

NOTE:

  • Log in the network according to CONSULT guidance.

  • For details the network connection and operation, refer to “CONSULT Operation Manual”.

>>

WORK END

    Other materials

    4wd Mode Does Not Change
    Description Vehicle does not enter 4-wheel drive mode even though 4WD warning turned to OFF. Diagnosis Procedure CHECK DTC OF TRANSFER CONTROL UNIT With CONSULT Ignition switch ON. Perform self-diagnosis for “AWD/4WD”. Is any DTC detected? YES >> Check DTC detected item. Refer to DT ...

    Front Door Module Assembly
    Removal and Installation REMOVALCAUTION: Before removing, take a short memo/photo to remember door harness and cable layout.Remove front door glass. Refer to Removal and Installation. Disconnect harness connectors , and then disengage harnesses fixing clips. : Clip Remove hole seals from fro ...

    Rear Bumper
    Exploded View Rear bumper side bracket LH Rear bumper bracket RH Rear bumper bracket LH Hands free sensor bracket (with hands free sensor models) Double-sided tape [t: 1.2 mm (0.047 in)] (with hands free sensor models) Rear bumper fascia Rear bumper molding LH Rear bumper fi ...