Work Procedure
Description
Vehicle specification needs to be written with CONSULT because it is not written after replacing the ABS actuator and electric unit (control unit). For details the operation, refer to “CONSULT Operation Manual”.
Work Procedure [After Replace ABS actuator and electric unit (control unit)]
WRITING VEHICLE SPECIFICATION
With CONSULT
Perform writing vehicle specification to ABS actuator and electric unit (control unit) according to "Replace ECU" in CONSULT Operation Manual.
>>
GO TO 2.
PERFORM NECESSARY WORK
-
Perform configuration. Refer to Description.
-
Perform air bleeding. Refer to Description.
-
Perform adjustment of steering angle sensor neutral position. Refer to Description.
-
Perform calibration of decel/side G sensor. Refer to Description.
-
Adjustment of rear brake caliper initialization position. Refer to Description.
-
Perform the change of system mode. Refer to Description.
-
Perform self-diagnosis for “All self diagnosis result”.
-
Erase the memory of self-diagnosis results.
>>
End of work.
Other materials
Sonar system limitations
WARNING
The following limitations apply to the Nissan Armada sonar system. Failure
to understand and follow these limitations may result in serious injury or even
fatal accidents.
Carefully review all limitations of the Nissan Armada sonar system. Environmental
conditions such as heavy r ...
Precautions
Precautions for Removing Battery Terminal
When disconnecting the 12V battery terminal, turn off the ACC power before disconnecting the 12V battery terminal, observing “How to disconnect 12V battery terminal” described below.
NOTE:
Some ECUs operate for a certain fixed time even after ignit ...
Precautions
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"
The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger fo ...