Description
Vehicle specification needs to be written with CONSULT because it is not written after replacing the air bag diagnosis sensor unit.
CONSULT connects to network and then it downloads the configuration data from the server. Then CONSULT writes the vehicle specification to the air bag diagnosis sensor unit. Refer to Work Procedure.
NOTE:
For details the operation, refer to “CONSULT Operation Manual”.
Work Procedure
WRITING VEHICLE SPECIFICATION
With CONSULT
Perform writing vehicle specification to air bag diagnosis sensor unit according to "Replace ECU" in "CONSULT Operation Manual".
>>
GO TO 2
CHECK ALL ECU SELF-DIAGNOSIS RESULTS
With CONSULT
-
Erase all ECU self-diagnosis results using CONSULT.
-
Ignition switch OFF.
-
Ignition switch ON.
-
Check that all ECU self-diagnosis results have no DTC.
>>
WORK END
Other materials
Hands On Detection
Basic information
In the Nissan Armada, the Hands On Detection system is an essential safety feature
integrated within Steering Assist and ProPILOT Assist technologies. This system
continuously monitors the driver’s interaction with the steering wheel through built-in
sensors, ensuring that ...
Additional Service When Replacing Sub-Tcm
Description
WARNING:
Jacking up or lift up the vehicle may the vehicle height to go down which cause a personal injury and/or damage to the air suspension component parts. Refer to Precaution for when Jacking and Lifting Up the vehicle with Electronic Air Suspension System.
When replacing the ...
4wd Mode Does Not Change
Description
Vehicle does not enter 4-wheel drive mode even though 4WD warning turned to OFF.
Diagnosis Procedure
CHECK DTC OF TRANSFER CONTROL UNIT
With CONSULT
Ignition switch ON.
Perform self-diagnosis for “AWD/4WD”.
Is any DTC detected?
YES >>
Check DTC detected item. Refer to DT ...