Removal and Installation
Exploded ViewPlastic Repair
Plastic welding can be used as a repair method only on thermoplastics.
Work preparation
Repairs must always be carried out from the inner to the outer side of the component, which means that in most cases, it is necessary to disassemble the damaged body component.
The repair area must always be thor ...
Removal and Installation
REMOVAL
Remove rear A/C unit assembly. Refer to Removal and Installation.
Disconnect rear air mix door motor harness connector .
Remove fixing screws , and then remove rear air mix door motor.
INSTALLATION
Install in the reverse order of removal. ...
Removal and Installation
WARNING:
REMOVAL
The ignition switch OFF.
CAUTION:
Wait for 60 seconds after the ignition switch OFF.
Disconnect negative battery terminal. Refer to Removal and Installation
Disconnect the transfer control actuator connector .
Remove harness clip .
Remove transfer control actuator mounting bolt ...