Nissan Armada 2025-2026 Service and Repair Manual: Frame Securing
Frame repair work requires larger straightening force than uni-bodies. Therefore, the frame to be repaired must be anchored stably and securely to withstand such large force. The anchoring methods used for the frame and straightening equipment (puller) must be carefully selected according to the degree of the damage and the facility environment of the body shop. Typical frame anchoring methods are explained below.
Measurement with Three-dimensional Measuring Equipment
Measure the dimensions using three-dimensional measuring equipment and compare the measurements with the vehicle body alignment dimensions to identify any deformation in each direction. Several types ...
Anchoring by Rigid Racks and Chains
Place the frame on rigid racks and pull the high strength/rigidity portions with chains. Thus, secure the frame tightly in the vertical direction. The rigid racks sustain the frame from below and the ...
Other materials:
Removal and Installation
REMOVAL
Apply protective tape (A) to rear door panel around rear door weather-strip fixing clips for preventing damage.
Disengage fixing clips on the reverse side of rear door weather-strip using a remover tool (A).
: Clip
CAUTION:
Never damage rear door panel.
When removing, never confuse ...
Work Flow
OVERALL SEQUENCE
DETAILED FLOW
GET INFORMATION FOR SYMPTOM
Get detailed information from the customer about the symptom (the condition and the environment when the incident/malfunction occurs).
Check operation condition of the function that is malfunctioning.
>>
GO TO 2.
CHECK DTC
Check DT ...
Work Procedure (Group A)
*1: When the same malfunction is detected in two consecutive trips, MIL will illuminate.
CHECK DTC
Check DTC.
Is any DTC detected?
YES>>
Repair malfunction(s) and erase DTC.
NO>>
GO TO 2 .
CHECK PERMANENT DTC
With CONSULT
Ignition switch OFF and wait at least 10 seconds.
Ignitio ...
0.0051