Diagnosis Procedure
CHECK “AUTO DOOR UNLOCK� SETTING IN COMBINATION METER
Check “Auto Door Unlock� setting is “Ignition OFF�.
Is the inspection result normal?
YES>>GO TO 2.
NO>>Set “IGN OFF� in combination meter.
REPLACE BCM
-
Replace BCM. Refer to Removal and Installation.
-
Confirm the operation after replacement.
Is the result normal?
YES>>INSPECTION END
NO>>Check intermittent incident. Refer to Intermittent Incident.
Other materials
Rear Suspension Member Stay
Exploded View
Rear suspension member stay
Final drive mounting bracket
: Always replace after every disassembly.
: N·m (kg-m, ft-lb)
Removal and Installation
WARNING:
Jacking up or lift up the vehicle may the vehicle height to go down which cause a personal injury an ...
Indicator Unit
Exploded View
Cover
Indicator unit
Removal and Installation
REMOVALRemove cover. Refer to Removal and Installation.
Remove indicator unit fixing screws , and then remove indicator unit.
INSTALLATIONInstall in the reverse order of removal. ...
Intelligent Key Unit
Removal and Installation
REMOVALCAUTION:
When replacing the Intelligent Key unit, always replace it with a new one. The functions controlled by the Intelligent Key unit does not operate properly in case of reuse of the Intelligent Key unit from another vehicle.Remove luggage side lower finisher LH. ...