Nissan Armada 2025-2026 Service and Repair Manual: Inspection

Nissan Armada 2025-2026 Service and Repair Manual / Brakes / Brake System — Removal and Installation / Rear Disc Brake / Inspection

INSPECTION AFTER DISASSEMBLY

Check the following items and replace if necessary.

Cylinder Body

Check the cylinder inner wall for rust, wear, cracks or damage.

CAUTION:

Always clean with new brake fluid. Never clean with mineral oil such as gasoline and light oil.

Torque Member

Check the torque member for rust, wear, cracks or damage.

Sliding Pin, Sliding Pin Boot and Bushing

Check the sliding pins, sliding pin boots and bushing for rust, wear, cracks or damage.

INSPECTION AFTER INSTALLATION

Check a drag of rear disc brake. If any drag is found, follow the procedure described below.
1. Remove brake pads. Refer to Removal and Installation.
2. Press the pistons. Refer to Removal and Installation.
3. Install brake pads. Refer to Removal and Installation.
4. Depress the brake pedal several times.
5. Check a drag of rear disc brake again. When any drag is found, disassemble the cylinder body and replace if necessary. Refer to Disassembly and Assembly.
Burnish contact surfaces brake pads and disc rotor after refinishing or replacing disc rotor, or if a soft pedal occurs at very low mileage. Refer to Inspection and Adjustment.

Disassembly and Assembly

DISASSEMBLY NOTE: Never remove the torque member and brake pad when disassembling and assembling the cylinder body. Remove the sliding pin bolt, and remove the cylinder body from the torque member. Re ...

Brake System — Service Data and Specifications (sds)

...

Other materials:

Symptom Table
Symptom Possible cause Inspection item/Work item ””is displayed Front camera (driving video recorder) abnormality Rear camera (driving video recorder) abnormality Inside camera (driving video recorder) abnormality Perform diagnosis procedure ”” is displayed Wi-Fi abnormality Perfor ...

Anti-corrosive Wax
To improve corrosion resistance, anti-corrosive wax is applied inside the body sill and inside other closed sections. Accordingly, when replacing these parts, be sure to apply anti-corrosive wax to the appropriate areas of the new parts. Select an excellent anti-corrosive wax which will penetrate af ...

Inspection Procedure
INSTRUMENT PANEL Most incidents are caused by contact and movement between: Cluster lid A and instrument panel Acrylic lens and combination meter housing Instrument panel to front pillar garnish Instrument panel to windshield Instrument panel mounting pins Wiring harnesses behind the combination met ...

0.0054