Description
Intelligent Key system all functions cannot operate (door lock and engine start). (One Intelligent Key has the symptom, other keys operate normally.)
SYMPTOM TABLE (ONE INTELLIGENT KEY HAS THE SYMPTOM, OTHER KEYS OPERATE NORMALLY)
| Door lock operation (remote keyless entry) | Door lock operation (one touch sensor or request switch of front/rear/back door) or trunk/back door open operation (opener switch of trunk/back door panel) | Engine started with push-button ignition switch operation (Intelligent Key is within the detection area of inside key antenna) | Engine started with push-button ignition switch operation (registered Intelligent Key placed next to push-button ignition switch) | Unlock operation when approaching the vehicle, lock operation when away from the vehicle (registered Intelligent Key is within the detection area of outside key antenna) |
|---|---|---|---|---|
| NG | NG | No crank, No start | No crank, No start | NG |
DIAGNOSIS PROCEDURE
Refer to Diagnosis Procedure.
Diagnosis Procedure
CHECK INTELLIGENT KEY SYSTEM SYMPTOM TABLE
Check Intelligent Key system symptom table.
Refer to Diagnosis Procedure.
>>
GO TO 2.
CHECK INTELLIGENT KEY-1
For Intelligent Key that cannot be used for door lock and unlock, check that the Intelligent Key belongs to the vehicle to be checked.
Does the Intelligent Key belong to the vehicle to be checked?
YES>>GO TO 3.
NO>>Check Intelligent Key button operation using a registered Intelligent Key that belongs to the vehicle.
CHECK INTELLIGENT KEY-2
Check the inside of the Intelligent Key for rust or corrosion by water. Simultaneously check the internal circuits for damage.
Is the inspection result normal?
YES>>GO TO 4.
NO>>Replace Intelligent Key.
REGISTER INTELLIGENT KEY
-
Register the Intelligent Key again.
-
Check the operation after replacement.
Is the inspection result normal?
YES>>INSPECTION END
NO>>GO TO 5.
REPLACE INTELLIGENT KEY
-
Replace the Intelligent Key and perform registration again.
-
Check operation after replacement.
Is the inspection result normal?
YES>>INSPECTION END
NO>>GO TO 6.
REPLACE INTELLIGENT KEY UNIT
-
Replace Intelligent Key unit. Refer to Removal and Installation.
-
Check operation after replacement.
Is the inspection result normal?
YES>>INSPECTION END
NO>>Check intermittent incident. Refer to Intermittent Incident.
Other materials
Additional Service When Replacing Electrical Brake Control Unit
Work Procedure
DescriptionWhen replacing the electrical brake control unit, the procedures of AFTER REPLACEMENT must be performed.CAUTION:
If the electrical brake control unit is undamaged, do not decide to replace it based on DTC detected in the past.AFTER REPLACEMENTAfter replacing the electrical ...
Rear A/c Control
Exploded View
Refer to Exploded View.
Removal and Installation
REMOVALRemove front center console rear finisher assembly. Refer to Removal and Installation.
Remove fixing screws , and then remove rear A/C control assembly.
Remove fixing screws , and then remove rear A/C control from rear A/C contr ...
Av Control Unit
Exploded View
Bracket RH
AV control unit
Bracket LH
: vehicle front
Removal & Installation
CAUTION:
Before replacing AV control unit, perform "ADDITIONAL SERVICE WHEN REPLACING AV CONTROL UNIT". For details, Refer to Work Procedure.ADDITIONAL SERVICE WHEN REPLACINGIf the following ...