Basic information
The Nissan Armada display guide lines and their projected positions on the ground are intended as approximate references only and should not be relied upon as exact measurements.
Due to factors such as road incline, uneven terrain, and objects that extend outward, the actual distance of objects may differ significantly from what is shown on the Nissan Armada monitor relative to the guide lines.
For maximum safety when reversing your Nissan Armada, always verify surroundings by turning your head, using mirrors, or exiting the vehicle if necessary to visually confirm object positions.

Backing up on a steep uphill
When reversing the Nissan Armada uphill, the distance guide lines and vehicle width indicators will appear closer than the actual distance.
This means that objects displayed on the monitor are farther away than they appear, requiring extra caution when maneuvering.

Backing up on a steep downhill
When reversing downhill in the Nissan Armada, the guide lines will appear farther than the actual distance.
As a result, objects are closer than they seem on the display, increasing the risk of misjudgment if relying solely on the screen.

Backing up near a projecting object
The Nissan Armada predictive course lines A may visually avoid contact with an object on the display.
However, if the object extends into the actual driving path, the Nissan Armada may still come into contact with it despite what is shown on the screen.

Backing up behind a projecting object
On the Nissan Armada display, position C may appear farther away than position B.
In reality, position C is at the same distance as position A. This visual distortion can lead to incorrect judgment, and the Nissan Armada may strike the object if it extends into the vehicle’s path.
Other materials
Idle Air Volume Learning
Description
Idle Air Volume Learning is a function of ECM to learn the idle air volume that keeps engine idle speed within the specific range. It must be performed under the following conditions:
Each time electric throttle control actuator or ECM is replaced.
Idle speed or ignition timing is out ...
Electronic Air Suspension System
Work Support
For each work support, follow the procedure shown in CONSULT.The table below shows the additional explanations provided in the CONSULT.CAUTION:
At the end of the work, be sure to perform a “Vehicle height adjustment” and adjust the vehicle to NORMAL height before returning it to the ...
Power Supply, Ground & Circuit Elements Tools and Preparation
Special Service Tools
Tool number
(TechMate No.)
Tool name Description
—
(—) Model GR8-1200 NI
Multitasking battery and electrical diagnostic station
Tests batteries, starting and charging systems and charges batteries.
For operating instructions, refer to diagnostic station instr ...