Description
All doors do not lock/unlock using one touch sensor and engine does not start when push-button ignition switch is pressed while carrying Intelligent Key. (One Intelligent Key has the symptom, other keys operate normally.)
SYMPTOM TABLE (ONE INTELLIGENT KEY HAS THE SYMPTOM, OTHER KEYS OPERATE NORMALLY)
| Door lock operation (remote keyless entry) | Door lock operation (one touch sensor or request switch of front/rear/back door) or trunk/back door open operation (opener switch of trunk/back door panel) | Engine started with push-button ignition switch operation (Intelligent Key is within the detection area of inside key antenna) | Engine started with push-button ignition switch operation (registered Intelligent Key placed next to push-button ignition switch) | Unlock operation when approaching the vehicle, lock operation when away from the vehicle (registered Intelligent Key is within the detection area of outside key antenna) |
|---|---|---|---|---|
| NG | NG | No crank, No start | OK | NG |
DIAGNOSIS PROCEDURE
Refer to Diagnosis Procedure.
Diagnosis Procedure
CHECK INTELLIGENT KEY SYSTEM SYMPTOM TABLE
Check Intelligent Key system symptom table.
Refer to Diagnosis Procedure.
>>
GO TO 2.
CHECK INTELLIGENT KEY
Check the inside of the Intelligent Key for rust or corrosion by water. Simultaneously check the internal circuits for damage. Squeeze, twist or bend the Intelligent Key and check the functionality again. Is the Intelligent Key operating normally?
Is the inspection result normal?
YES>>GO TO 3.
NO>>Replace Intelligent Key.
CHECK INTELLIGENT KEY BATTERY
Check the Intelligent Key battery.
Refer to Component Inspection.
Is the inspection result normal?
YES>>GO TO 4.
NO>>Replace Intelligent Key battery. Refer to Removal and Installation.
REGISTER INTELLIGENT KEY
-
Register the Intelligent Key again.
-
Check operation after replacement.
Is the inspection result normal?
YES>>INSPECTION END
NO>>GO TO 5.
REPLACE INTELLIGENT KEY
-
Replace the Intelligent Key and perform registration again.
-
Check operation after replacement.
Is the inspection result normal?
YES>>INSPECTION END
NO>>GO TO 6.
REPLACE INTELLIGENT KEY UNIT
-
Replace Intelligent Key unit. Refer to Removal and Installation.
-
Confirm the operation after replacement.
Is the inspection result normal?
YES>>INSPECTION END
NO>>Check intermittent incident. Refer to Intermittent Incident.
Other materials
Hill Start Assist system
WARNING
Never depend solely on the Hill Start Assist system in the Nissan Armada
to prevent rollback when starting on an incline. Always remain attentive and
keep full control of the vehicle. When stopped on a steep hill, firmly press
the brake pedal. Extra caution is required on icy, m ...
Basic information
The Idling Stop System in the Nissan Armada is designed to enhance fuel efficiency,
reduce exhaust emissions, and minimize unnecessary engine noise during short stops
such as traffic lights or congestion.
When the Nissan Armada comes to a complete stop, the system automatically
shuts off ...
Mac Key Writing
Description
When replacing ECM, it is necessary to write MAC key to ECM. Write MAC key to ECM according to "MAC Key writing" procedure of "CONSULT Operation Manual". Refer to Work Procedure.CAUTION:
During MAC key writing, maintain the following conditions:
Ignition switch ON
CONSULT is connecte ...