Description
Always perform the memory storage when the driver seat control unit or steering column control module is replaced. The memory function will not operate normally if no memory storage is performed. For details, refer to Work Procedure.
Work Procedure
Memory Storage Procedure
Two positions for the seat, steering column, and door mirror can be stored for memory operation by following procedure.
NOTE:
Memory registration can be performed with no restrictions of the shift position, vehicle speed, and ignition switch position.
REGISTRATION METHOD
-
Adjust seat, steering column, and door mirror position manually.
-
Push set switch.
NOTE:
-
Memory indicator for which driver seat position is already retained in memory is illuminated for 5 seconds.
-
Memory indicator for which driver seat position is not retained in memory is illuminated for 0.5 seconds.
-
-
Push the memory switch (1 or 2) for at least 1 second within 5 seconds after pushing the set switch.
NOTE:
-
When registration is performed correctly, the memory indicator blinks for 5 seconds and a buzzer sounds.
-
If memory is stored in the same memory switch, the previous memory will be deleted.
-
-
Confirm the operation of each part with memory operation.
>>
WORK END
Other materials
Idling Stop System display
Basic information
The current operating status of the Idling Stop System in the Nissan Armada can
be easily monitored through the vehicle information display, allowing the driver
to stay informed about system activity and performance.
Idling Stop System indicator
This indicator appears wh ...
If your vehicle overheats
CAUTION
Never continue driving your Nissan Armada if the engine temperature rises
excessively. Doing so may result in severe engine damage or even a vehicle fire.
To prevent burns, never remove the radiator cap or coolant reservoir
cap while the Nissan Armada engine is hot. Pressurized h ...
The Meter Speaker Does Not Sound
Diagnosis Procedure
The meter speaker does not sound.CHECK COMBINATION METER INPUT SIGNAL
Select the “Data Monitor� for the “Combination meter� and check the “BUZZER� monitor value.
“BUZZER�
Under the condition of speaker input
: On
Other than the above
: Off
Is ...