ON BOARD DIAGNOSTIC (OBD) SYSTEM : Precautions
The ECM has an on board diagnostic system. It will illuminate the malfunction indicator lamp (MIL) to warn the driver of a malfunction causing emission deterioration.
CAUTION:
-
Always turn the ignition switch OFF and disconnect the negative battery cable before any repair or inspection work. The open/short circuit of related switches, sensors, solenoid valves, etc. will cause the MIL to illuminate.
-
Always connect and lock the connectors securely after work. A loose (unlocked) connector will cause the MIL to illuminate due to the open circuit. (Be sure the connector is free from water, grease, dirt, bent terminals, etc.)
-
Certain systems and components, especially those related to OBD, may use a new style slide-locking type harness connector. For description and how to disconnect, Refer to Harness Connector.
-
Always route and secure the harnesses properly after work. The interference of the harness with a bracket, etc. may cause the MIL to illuminate due to the short circuit.
-
Always connect rubber tubes properly after work. A misconnected or disconnected rubber tube may cause the MIL to illuminate due to the malfunction of the EVAP system or fuel injection system, etc.
-
Always erase the unnecessary malfunction information (repairs completed) from the ECM and TCM (Transmission control module) before returning the vehicle to the customer.
Other materials
Additional Service When Replacing Electric Shift Selector
Description
When electric shift selector is replaced, always perform "Replace ECU" of CONSULT function to write vehicle specifications. For work procedure, refer to Work Procedure.
Work Procedure
WRITING VEHICLE SPECIFICATIONS
With CONSULT
Ignition switch ON.
Select "ELECTRIC SHIFTER".
Select ...
Instrument Panel Assembly
Exploded View
INSTRUMENT PANEL ASSEMBLY
Front speaker grille*1
Display unit cover
Display unit
Instrument panel assembly
Instrument mask LH
Instrument finisher A
Display unit finisher LH
Instrument pad A
Steering column cover upper
Steering column cover lower
Instrum ...
Sonar System Symptoms
Symptom Table
Symptom Possible cause Reference page
Malfunction is detected in only 1 sensor of display.
Sonar sensor circuit
Sonar sensor
Perform CONSULT self-diagnosis. Perform detected DTC self-diagnosis. Refer to DTC Index.
Front sonar sensors do not activate.
Front sensor po ...