PRECAUTIONS FOR POP UP ENGINE HOOD : Precautions
WARNING:
Always observe the following items for preventing accidental activation.
-
Before removal or installation of the pop-up engine hood and harness, always OFF the ignition switch, disconnect the battery negative terminal, and wait for 3 minutes or more. (To discharge the accumulated electricity in the control unit auxiliary power supply circuit)
-
Never use pneumatic or electric tools, etc., to remove or install components of the pop-up engine hood.
-
Never repair the harness for the pop-up engine hood with a solder. Also, always avoid contact or interference between the harness and other parts.
-
Never use an electric tester like a circuit tester, etc., when inspecting the pop-up engine hood circuit or other individual parts. (To prevent activation due to the low voltage of the tester)
-
Never allow foreign materials like a screwdriver, etc., to enter the pop-up engine hood harness connector. (To prevent activation due to static electricity)
-
The yellow harness connector is used with the pop-up engine hood actuator for identification purposes compared to other harnesses.
Other materials
Fuel System
Hydraulic Layout
EVAP canister purge volume control solenoid valve
EVAP resonator
EVAP line
Fuel line
Fuel tank
Fuel filler neck
EVAP canister
Quick Connector
CAUTION:
After connecting fuel tube quick connectors, check quick connectors are secur ...
Upper Link
Exploded View
Frame
Upper link
Steering knuckle
: Always replace after every disassembly.
: N·m (kg-m, ft-lb)
Removal and Installation
WARNING:
Jacking up or lift up the vehicle may the vehicle height to go down which cause a personal injury and/or damage to the air suspension ...
Second Seat Cushion
Disassembly and Assembly
DISASSEMBLYRemove seatback trim and pad. Refer to Disassembly and Assembly.
Disengage seat cushion trim fixing retainers .
Disengage seat cushion trim fixing retainers .
Disengage harness fixing clip of seat cushion, and then disconnect harness connector.
CAUTION:
Before ...