Removal and Installation
REMOVAL
Remove back door lower finisher. Refer to Removal and Installation.
Disconnect rear camera (driving video recorder) harness connector 
.
Remove mounting bolts , and remove rear camera (driving video recorder) from vehicle.
INSTALLATION
Install in the reverse order of removal.
CAUTION:
-
Do not touch or shock the rear camera (driving video recorder) lens area or drop the rear camera (driving video recorder).
-
Make sure that the rear camera (driving video recorder) harness is not twisted after installation.
Other materials
Road Wheel Tire
Exploded View
Tire
Air valve
Wheel
: For non-reusable parts, refer to the TPMS configuration diagram.
Refer to TIRE PRESSURE SENSOR : Exploded View.
: N·m (kg-m, ft-lb)
Removal & Installation
WARNING:
Jacking up or lift up the vehicle may the vehicle height to go down which ...
Normal Operating Condition
Information Display
Description
DISTANCE TO EMPTYThe calculated distance to empty may differ from the actual distance to empty if the refueling amount is approximately 6 (1 3/8 Imp gal) or less. This is because the refuel control (moves the fuel gauge needle quicker than normal judging that the dr ...
Mac Key Writing
Description
When replacing around view monitor control unit, it is necessary to write MAC key to around view monitor control unit. Write MAC key to around view monitor control unit according to "MAC Key writing" procedure of "CONSULT Operation Manual". Refer to Work Procedure.CAUTION:
During MAC key ...