Nissan Armada owner resource

Manuals, service information and practical owner guidance.

Fast access to Nissan Armada owner manuals, service procedures, maintenance references, technical information and practical guides for different Armada generations.

Browse manuals →
Nissan Armada manual library

Nissan Armada 2025-2026 Service and Repair Manual: Rear Propeller Shaft: 2f C-C

Inspection

WARNING:

  • Jacking up or lift up the vehicle may the vehicle height to go down which cause a personal injury and/or damage to the air suspension component parts. Refer to Precaution for when Jacking and Lifting Up the vehicle with Electronic Air Suspension System.

LOOSENESS OF CONNECTED PART

Check each fixing bolt and nut for looseness using torque wrench. For each tightening torque, refer to Exploded View.

BACKLASH OF JOINT PART

Move the joint of propeller shaft up and down and from side to side (axial direction of shaft and right angle to shaft) to check that the joint has no backlash extremely. If the joint has a malfunction, remove propeller shaft and perform inspection.

APPEARANCE AND NOISE

Check propeller shaft tube surface for dents or cracks. If malfunction is detected, replace propeller shaft assembly.

VIBRATION

If vibration is present at high speed, adjust the propeller shaft phase first.

Check the propeller shaft for bend and damage. If damaged, replace propeller shaft assembly.

Perform a cruise test drive to check the propeller shaft for runout. If vibration occurs, separate propeller shaft at final drive companion flange; then change the phase between companion flange and propeller shaft by the one bolt hole at a time and install propeller shaft.

If vibration is still detected, measure propeller shaft runout after removing it. Refer to Inspection.

    Other materials

    Engine Lubrication System Tools and Preparation
    Special Service Tools The actual shapes of TechMate tools may differ from those of special service tools illustrated here. Tool number (TechMate No.) Tool name Description ST25051001 (NI-25695-1) Oil pressure gauge Measuring oil pressure Maximum measuring range: 2,452 kPa (25 kg/cm2, 356 psi ...

    Rear Automatic Air Conditioning System
    Work Procedure DESCRIPTIONThe purpose of the operation inspection is to check that the individual system operates normally. NOTE: Check that front automatic air conditioning system operates normally. Refer to Work Procedure. Check condition : Engine running at normal operating temperature. OPERA ...

    Road Wheel
    Service Data ALUMINUM WHEEL Item Limit Runout Axial runout 0.3 mm (0.012 in) or less Radial runout Allowable unbalance Dynamic (At flange) 5 g (0.17 oz) or less (one side) Static (At flange) 10 g (0.35 oz) or less ALUMINUM WHEEL (EMERGENCY) Item Limit Runout Axial runout ...