Nissan Armada 2025-2026 Service and Repair Manual: Rear Fillet Molding Front

Removal and Installation

REMOVAL Remove front fillet molding fixing screws . Apply protective tape (A) on the part to protect it from damage. Disengage front fillet molding fixing pawl indicated by arrows as shown in the ...

Removal and Installation

REMOVAL Apply protective tape (A) on the part to protect it from damage. Insert a remover tool (A) between rear fillet molding front and rear door panel, cut double-sided tape using a cutter (B) whi ...

Other materials:

Changing
WARNING: Recommended fluid and fluid capacity Refer to Fluids and Lubricants. CAUTION: Use only recommended A/T fluid. Never mix with other A/T fluid. Start the engine. Adjust the A/T fluid temperature to be approximately 50°C (122°F). NOTE: Check with “Fluid temperature” in “TRANSMISS ...

Hooks and Other Tools
(1) HOOKS Unlike clamps which grab an object, hooks are curved tools that pull on the body. When a hook is used, it must be set so that the point where the body is pulled and the position of the hook's chain are lined up straight. When a hook is used, a piece of wood, etc. should be inserted betwee ...

Work Procedure
PERFORM SYSTEM INITIALIZATION Close moonroof and sunshade. Press and hold the moonroof switch CLOSE for approximately 10 seconds. Moonroof and sunshade will move as following. Moonroof tilt up, and the sunshade slightly close and stops. Release the moonroof switch, and continue to press the moonroof ...