Fluids and Lubricants
Recommended Fluid and Lubricants
The following are approximate capacities. The actual refill capacities may be slightly different. When refilling, follow the procedures described elsewhere in this manual.
| Fluid type | Capacity (approximate) | Recommended Fluids/Lubricants | ||||
|---|---|---|---|---|---|---|
|
Metric Measure |
US Measure |
Imperial Measure | ||||
|
Engine oil Drain and refill |
With oil filter change | 6.0![]() |
6-3/8 qt | 5-2/8 qt |
|
|
| Without oil filter change | 5.6 ![]() |
5-7/8 qt | 4-7/8 qt | |||
| Dry engine (engine overhaul) | 7.2 ![]() |
7-5/8 qt | 6-3/8 qt | |||
| Engine coolant | With reservoir tank | 13.0 ![]() |
13-6/8 qt | 11-4/8 qt |
|
|
| Reservoir tank | 1.61 ![]() |
1-6/8 qt | 1-3/8 qt | |||
| Automatic transmission fluid | 10.0 *1 |
10-5/8 qt*1 | 8-6/8 qt*1 |
|
||
| Brake fluid | — | — | — |
|
||
| Transfer fluid | 1.8 ![]() |
1-7/8 qt | 1-5/8 qt |
|
||
| Differential gear oil | Front | 0.85 ![]() |
7/8 qt | 6/8 qt |
|
|
| Rear | R240 | 2.0 ![]() |
2-1/8 qt | 1-6/8 qt |
|
|
| R240 (DL) | 1.9 ![]() |
2 qt | 1-5/8 qt | |||
| Multi-purpose grease | — | — | — |
|
||
*1: The fluid capacity is the reference value.
SAE Viscosity Number
GASOLINE ENGINE
INFINITI recommends the use of an energy conserving oil in order to improve fuel economy.
Select only engine oils that meet the American Petroleum Institute (API) certification and International Lubrication Standardization and Approval Committee (ILSAC) certification and SAE viscosity standard. These oils have the API certification mark on the front of the container. Oils which do not have the specified quality label should not be used as they could cause engine damage.

![]() |
API certification mark | ![]() |
API service symbol | ||
Anti-Freeze Coolant Mixture Ratio
The engine cooling system is filled at the factory with a pre-diluted mixture of 50% Genuine NISSAN Long Life Antifreeze/Coolant (blue) and 50% water to provide year-round anti-freeze and coolant protection. The antifreeze solution contains rust and corrosion inhibitors. Additional engine cooling system additives are not necessary.
WARNING:
-
Never remove the radiator or coolant reservoir cap when the engine is hot. Wait until the engine and radiator cool down. Serious burns could be caused by high pressure fluid escaping from the radiator.
-
The radiator is equipped with a pressure type radiator cap. To prevent engine damage, use only a Genuine NISSAN radiator cap.
CAUTION:
-
When adding or replacing coolant, be sure to use only Genuine NISSAN Long Life Antifreeze/Coolant (blue) or equivalent. Genuine NISSAN Long Life Antifreeze/Coolant (blue) is pre-diluted to provide antifreeze protection to -34°F (-37°C). If additional freeze protection is needed due to weather where your vehicle is operated, add Genuine NISSAN Long Life Antifreeze/Coolant (blue) concentrate following the directions on the container. If an equivalent coolant other than Genuine NISSAN Long Life Antifreeze/Coolant (blue) is used, follow the coolant manufacturer’s instructions to maintain minimum antifreeze protection to -34°F (-37°C). The use of other types of coolant solutions other than Genuine NISSAN Long Life Antifreeze/Coolant (blue) or equivalent may damage the engine cooling system.
-
Mixing any other type of coolant other than Genuine NISSAN Long Life Antifreeze/Coolant (blue), including Genuine NISSAN Long Life Antifreeze/Coolant (green), or the use of non-distilled water will reduce the life expectancy of the factory filled coolant.
Other materials
Front Propeller Shaft
Inspection
WARNING:
Jacking up or lift up the vehicle may the vehicle height to go down which cause a personal injury and/or damage to the air suspension component parts. Refer to Precaution for when Jacking and Lifting Up the vehicle with Electronic Air Suspension System.
LOOSENESS OF CONNECT ...
Automatic Back Door Control Unit
Removal and Installation
REMOVALRemove luggage side lower finisher LH. Refer to Removal and Installation.
Disconnect automatic back door control unit harness connector.
Remove automatic back door control unit mounting nuts , and then remove automatic back door control unit .
INSTALLATIONInstall in ...
Additional Service When Replacing Audio Amp.
Work Procedure
CAUTION:
When after replacing audio amp, Configuration must be performed. Or not doing so, audio amp. control function does not operate normally.REPLACE AUDIO AMP.
Replace audio amp. Refer to Removal & Installation.
>>
GO TO 2.
PERFORM AUDIO amp. CONFIGURATION
Perform aud ...


