Chevrolet Sonic manuals

Nissan Armada 2025-2026 Service and Repair Manual: Recycle Refrigerant

WARNING:

Perform lubricant return operation. Refer to Perform Lubricant Return Operation. (If refrigerant or lubricant leakage is detected in a large amount, omit this step, and then GO TO 2.)

CAUTION:

Never perform lubricant return operation if a large amount of refrigerant or lubricant leakage is detected.

Check gauge pressure readings of recovery/recycling/recharging equipment. When remaining pressure exists, recycle refrigerant from high-pressure hose and low-pressure hose.

NOTE:

Follow manufacturer instructions for the handling or maintenance of the equipment. Never fill the equipment with non-specified refrigerant.

Remove A/C service valve cap from the vehicle.

Connect recovery/recycling/recharging equipment to A/C service valve.

Operate recovery/recycling/recharging equipment, and recycle refrigerant from the vehicle.

Evacuate air for 10 minutes or more to remove any remaining refrigerant integrated to compressor lubricant, etc.

Refrigerant recycle operation is complete.

Leak Test
CHECK REFRIGERANT LEAKAGE USING ELECTRICAL LEAK DETECTOR WARNING: Never check refrigerant leakage while the engine is running. CAUTION: Be careful of the following items so that inaccurate checks or m ...

Charge Refrigerant
WARNING: Always use HFO-1234yf for A/C refrigerant. If CFC-12 or HFC-134a is accidentally charged, A/C compressor is damaged due to insufficient lubrication. Always observe and follow precautions desc ...

Other materials:

Approach Unlock/walk Away Lock Function Does Not Operate (all Keys)
Approach unlock/walk away lock function does not operate. NOTE: SYMPTOM TABLE (BOTH INTELLIGENT KEYS HAVE THE SAME SYMPTOMS) Door lock operation (remote keyless entry) Door lock operation (one touch sensor or request switch of front/rear/back door) or trunk/back door open operation (opener switch ...

Inspection
INSPECTION AFTER DISASSEMBLY Drive Gear and Drive Pinion Clean up the disassembled parts. If the gear teeth never mesh or line-up correctly, determine the cause and adjust or replace as necessary. If the gears are worn, cracked, damaged, pitted or chipped (by friction) noticeably, replace with new d ...

Normal Operating Condition
FUEL CUT CONTROL (AT NO LOAD AND HIGH ENGINE SPEED) If the engine speed is above 2,500 rpm under no load (for example, the shift position is neutral and engine speed is over 2,500 rpm) fuel will be cut off after some time. The exact time when the fuel is cut off varies based on engine speed. Fuel cu ...

© 2014-2026 Copyright www.niarmada.com
 
0.0073