Nissan Armada 2025-2026 Service and Repair Manual: Removal and Installation
WARNING:
REMOVAL
Remove tires. Refer to ROAD WHEEL TIRE : Removal & Installation.
Disconnect front wheel sensor harness connectors and remove harness clip.
Remove grommet from bracket.
Remove front wheel sensor mounting bolt.
Remove front wheel sensor from steering knuckle.
CAUTION:
Never rotate and never pull front wheel sensor as much as possible, when pulling out.
Remove front wheel sensor harness from the vehicle.
CAUTION:
Never twist or pull front wheel sensor harness, when removing.
INSTALLATION
Note the following, and install in the reverse order of the removal.
Check that there is no foreign material like iron powder or damage on inner surface of front wheel sensor mounting hole of steering knuckle and sensor rotor. Install after cleaning when there are foreign material like iron powder, or replace when there is a malfunction.
Never twist front wheel sensor harness when installing front wheel sensor. Check that grommet
is fully inserted to bracket 
. Check that front wheel sensor harness is not twisted after installation.
CAUTION:
Check that front wheel sensor identification line
faces toward the vehicle front.
Exploded View
Front LH wheel sensor Bracket Steering knuckle : Vehicle front : N·m (kg-m, in-lb)
NOTE:
Front RH wheel sensor is symmetrically opposite of LH. ...
Other materials:
Precautions for Removing Battery Terminal
NOTE:
NOTE:
NOTE:
The removal of 12V battery may cause a DTC detection error.
HOW TO DISCONNECT 12V BATTERY TERMINAL
Disconnect 12V battery terminal according to instruction described below.
Open the hood.
Turn ignition switch to the ON position.
Turn ignition switch to the OFF position with the d ...
Additional Service When Replacing Intelligent Key Unit
CAUTION:
When replacing the Intelligent Key unit, always replace it with a new one. The functions controlled by the Intelligent Key unit does not operate properly in case of reuse of the Intelligent Key unit from another vehicle.
Perform the following operations when replacing Intelligent Key unit. ...
General Specification
Applied model Axle 4WD Engine VR35DDTT Transmission A/T Rear final drive R240 without differential lock Propeller shaft model 2S C-C Number of joints 2 Joint type 1st joint Universal (Solid type) 2nd joint Universal (Solid type) Coupling method Transfer side Sleeve type Rear fi ...
0.0075