Exploded View

![]() |
Tire | ![]() |
Air valve | ![]() |
Wheel |
![]() |
: For non-reusable parts, refer to the TPMS configuration diagram. Refer to TIRE PRESSURE SENSOR : Exploded View. |
||||
: N·m (kg-m, ft-lb) |
|||||
Removal & Installation
WARNING:
-
Jacking up or lift up the vehicle may the vehicle height to go down which cause a personal injury and/or damage to the air suspension component parts. Refer to Precaution for when Jacking and Lifting Up the vehicle with Electronic Air Suspension System.
REMOVAL
Remove wheel nuts with power tool (commercial service tool).
Remove tire assembly.
INSTALLATION
Note the following, install in the reverse order of removal.
-
When replacing or rotating wheels, perform the "TIRE PRESSURE SENSOR ID REGISTRATION". Refer to Work Procedure.
Inspection
ALUMINUM WHEEL
Check tires for wear and improper inflation.
Check wheels for deformation, cracks and other damage. If deformed, remove wheel and check wheel runout.Remove tire from aluminum wheel and mount on a tire balance machine. Set dial indicator as shown in the figure.

or radial runout
exceeds the limit, replace aluminum wheel.
| Limit | |
| Axial runout | Refer to ROAD WHEEL : Service Data. |
| Radial runout | Refer to ROAD WHEEL : Service Data. |
Other materials
Hill descent control system
Basic information
WARNING
Do not rely solely on the Hill Descent Control system in the Nissan Armada
to regulate speed on steep downhill slopes. Always maintain full control of
the vehicle and use the brake pedal when necessary. Extra caution is required
on slippery, muddy, icy, or ext ...
Transfer Control Unit
Exploded View
Transfer control unit
: N·m (kg-m, in-lb)
Removal and Installation
WARNING:
Jacking up or lift up the vehicle may the vehicle height to go down which cause a personal injury and/or damage to the air suspension component parts. Refer to Precaution for when Jacking an ...
Additional Service When Replacing Transfer Control Unit
Description
When replacing transfer control unit, the following work is required. For the work procedure, refer to Work Procedure.WORK AFTER REPLACEMENT
Unit parameter writing
Initial calibration
Work Procedure
WRITING THE REQUIRED INFORMATION FOR CONTROL UNIT REPLACEMENT
With CONSULT
Ignitio ...



: N·m (kg-m, ft-lb)