Exploded View
 |
Handle rod guide |  |
Spare wheel carrier assembly |  |
Spare tire and wheel assembly |
| : vehicle front | |||||
 |
: N·m (kg-m, ft-lb) | ||||
Removal & Installation
WARNING:
-
Jacking up or lift up the vehicle may the vehicle height to go down which cause a personal injury and/or damage to the air suspension component parts. Refer to Precaution for when Jacking and Lifting Up the vehicle with Electronic Air Suspension System.
REMOVAL
Remove the spare tire and wheel assembly from the spare wheel carrier assembly.
Remove the spare wheel carrier assembly mounting bolts, and then remove the spare wheel carrier assembly.
If necessary remove handle rod guide.
INSTALLATION
Installation is in the reverse order of removal.
Other materials
RAB system limitations
WARNING
The following limitations apply to the Rear Automatic Braking (RAB) system
in the Nissan Armada. Failure to fully understand and follow these limitations may
result in serious injury or even fatal accidents.
When the Nissan Armada approaches an obstacle while the accelerator or
b ...
Action Test
Work Procedure
Always perform the rear automatic braking system action test to check that the system operates normally after replacing the ADAS control unit 2 or repairing any rear automatic braking system malfunction.CHECK REAR AUTOMATIC BRAKING SYSTEM SETTING
Start the engine.
Check that the r ...
Automatic Back Door Control Unit
Removal and Installation
REMOVALRemove luggage side lower finisher LH. Refer to Removal and Installation.
Disconnect automatic back door control unit harness connector.
Remove automatic back door control unit mounting nuts , and then remove automatic back door control unit .
INSTALLATIONInstall in ...