Nissan Armada 2025-2026 Service and Repair Manual: Sheet Metal Work (aluminum)
Repairing aluminum alloy panels is basically the same as repairing steel panels. Special considerations for repairing aluminum alloy are listed below.
Aluminum Repair
...
Sanding
Aluminum alloy panels are softer than steel plates. It is important to select the proper type and grade of sanding disc. Also, care must be taken not to overgrind the surface.
Because aluminum powder ...
Other materials:
SONAR SENSOR (FRONT) : Removal & Installation
WARNING:
REMOVAL
Center sensor
NOTE:
When removing the sensor holder, remove the front bumper. Refer to Removal and Installation.
Disconnect sonar sensor harness connector , follow the procedure below.Slide the lock of the connector toward the direction (1). Keep pushing (2) in the lock of connecto ...
Adjustment of Brake Caliper Initial Position
CAUTION:
When performing the following operations, always use CONSULT (It cannot be performed by any means other than CONSULT.), for performing "Initialization position adjustment" of "Work support". Refer to Work Procedure.
×: Required —: not required
Procedure Initialization position adjustme ...
Work Procedure
WARNING:
CHECK DTC
With CONSULT
Start the engine.
Check DTC of all systems.
Is any DTC detected.
YES>>
Check DTC detected item.
NO>>
GO TO 2.
PERFORM TORQUE CONVERTER CLUTCH POINT LEARNING
With CONSULT
Check that the A/T fluid temperature is in the range of 60°C to 100°C (140°F t ...
0.0054