Removal and Installation
REMOVAL
Remove spiral cable assembly. Refer to Removal and Installation.
Remove steering angle sensor from spiral cable.
INSTALLATION
Note the following, and install in the reverse order of removal.
-
When replacing the angle sensor
, if the lock pin 
is installed, remove the lock pin after installing the angle sensor to the spiral cable.
CAUTION:
Perform steering angle sensor neutral position adjustment when steering angle sensor is removed and installed, or replaced. Refer to Work Procedure.
Other materials
About microSD card
WARNING
Never allow children to handle or play with the microSD card used in your
Nissan Armada. Due to its small size, accidental swallowing may occur, which can
lead to choking, serious injury, or even life-threatening situations.
NOTE:
If the microSD card is removed from the Nissan Armada ...
Side Oil Seal
Exploded View
Side oil seal
Front final drive assembly
: Always replace after every disassembly.
Removal and Installation
WARNING:
Jacking up or lift up the vehicle may the vehicle height to go down which cause a personal injury and/or damage to the air suspension component ...
Filament
Inspection and Repair
INSPECTIONWhen measuring voltage, wrap tin foil around the top of the negative probe. Then press the foil against the wire with your finger.
Attach probe circuit tester (in Volt range) to middle portion of each filament.
If a filament is burned out, circuit tester registers ...