Diagnosis Procedure
Fuel gauge will not indicate from a certain position.
CONDUCTING THE COMBINATION METER SELF-DIAGNOSIS MODE
Perform the self-diagnosis mode of combination meter, and then check that the fuel gauge operates normally. Refer to On Board Diagnosis Function.
Is the inspection result normal?
YES>>GO TO 2.
NO>>Replace the combination meter. Refer to Removal and Installation.
CHECK FLOAT INTERFERENCE
Check that the float arm interferes with or binds to other components in the fuel tank.
Is the inspection result normal?
YES>>GO TO 3.
NO>>Repair or replace malfunctioning part.
CHECK FUEL LEVEL SENSOR SIGNAL CIRCUIT
Check the fuel level sensor signal circuit. Refer to Component Function Check.
Is the inspection result normal?
YES>>Refer to Intermittent Incident.
NO>>Repair or replace malfunctioning parts.
Other materials
Engine Cover
Exploded View
Engine cover
Stud bolt
Engine cover bracket 1
Engine cover bracket 2
: N·m (kg-m, in-lb)
: N·m (kg-m, ft-lb)
Removal and Installation
REMOVALRemove engine cover.
If necessary r ...
Front Door Regulator
Exploded View
Front door regulator assembly is assembled on front door module assembly. Refer to Exploded View.
Removal and Installation
Front door regulator assembly is assembled on front door module assembly. If you need replace front door regulator, refer to Removal and Installation.
Disassembly ...
Microphone
Removal & Installation
REMOVALRemove the map lamp assembly. Refer to Removal and Installation.
Remove the microphone harness connector .
Use a suitable tool to release pawls and remove the switch finisher .
: Pawls
CAUTION:
Do not damage pawls.
Use a suitable tool to release pawl and re ...