NIARMADA Nissan Armada manuals & owner information
Nissan Armada owner resource

Manuals, service information and practical owner guidance.

Fast access to Nissan Armada owner manuals, service procedures, maintenance references, technical information and practical guides for different Armada generations.

Browse manuals →
Nissan Armada manual library

Nissan Armada 2025-2026 Service and Repair Manual: Transfer Control Actuator

Nissan Armada 2025-2026 Service and Repair Manual / Transmission & Driveline / Driveline. Transfer: Atx93c / Transfer Control Actuator

Exploded View

Transfer assembly Transfer control actuator bracket
: N·m (kg-m, in-lb)

Removal and Installation

WARNING:

  • Jacking up or lift up the vehicle may the vehicle height to go down which cause a personal injury and/or damage to the air suspension component parts. Refer to Precaution for when Jacking and Lifting Up the vehicle with Electronic Air Suspension System.

REMOVAL

The ignition switch OFF.

CAUTION:

Wait for 60 seconds after the ignition switch OFF.

Disconnect negative battery terminal. Refer to Removal and Installation

Disconnect the transfer control actuator connector .

Remove harness clip .

Remove transfer control actuator mounting bolt () and remove bracket .

Remove transfer control actuator .

INSTALLATION

Note the following, and install in the reverse order of removal.

  • Never damage oil seal of transfer control actuator.

  • Never contaminate or damage the oil seal mounting surface.

  • Perform inspection after installation. Refer to Inspection.

Inspection

INSPECTION AFTER REMOVAL

Check the oil seal assembled transfer control actuator for wear, crack and damage. Replace if there is malfunction.

Check the transfer assembly as follows.Install the suitable tool (A) to transfer assembly as shown in the figure.

When turn the shaft in direction , check returning to direction by spring power.

CAUTION:

The maximum turning force shall be 5 N·m (0.51 kg-m, 44 in-lb).

When turn the shaft in direction , check locking the shaft.

INSPECTION AFTER INSTALLATION

After driving, check the surface fitting transfer control actuator to transfer assembly for fluid leakage.

ADJUSTMENT AFTER INSTALLATION

When replacing transfer control actuator, performe writing unit parameter. Refer to Description.

    Other materials

    Radiator Core Support
    Exploded View Radiator air guide upper Radiator core support Radiator air guide RH Radiator air guide lower Radiator air guide LH     : N·m (kg-m, ft-lb) Radiator Core Support Removal and Installation REMOVALRemove radiator air guide upper. Refer to Removal and Insta ...

    Wiper Deicer Does Not Operate
    Diagnosis Procedure CHECK REAR WINDOW DEFOGGER Check rear window defogger. Refer to Component Function Check. Is the inspection result normal? YES>> GO TO 2. NO>> Repair or replace the malfunctioning parts. CHECK DOOR MIRROR DEFOGGER Check door mirror defogger. Refer to Component Funct ...

    Rear Camera
    Removal and Installation REMOVALRemove the back door finisher. Refer to Removal and Installation. Remove the rear camera mounting screws , then remove the rear camera . INSTALLATIONInstall in the reverse order of removal. Perform parameter writing. (With ProPILOT Assist 2.1) Refer to Work Procedur ...