Nissan Armada 2025-2026 Service and Repair Manual: With Tail Lamp

Exploded View

	Rear emblem		Emblem A		Emblem B
	Tail lamp RH		Rear emblem bracket		Double-sided tape [t: 1.2 mm (0.047 in)]
	: Clip
	: Pawl
	: Always replace after every disassembly.

Removal and Installation

REMOVAL

Apply protective tape (A) on the part to protect it from damage.

Disengage fixing pawls using remover tool (A), and then remove emblem A.

: Pawl

Remove emblem bracket mounting bolt.

Apply protective tapes (A) on the part to protect it from damage.

Cut double-sided tapes using remover tool (A) and cutter (B).

Disengage fixing pawl and clip using a remover tool (A), and then remove rear emblem bracket.

	: Clip
	: Pawl

Remove emblem A from back door finisher while warming using an industrial dryer.

CAUTION:

Never damage the painted surface of the back door finisher when removing.

Remove emblem B from the panel while warming using an industrial dryer.

CAUTION:

Never damage the painted surface of the panel when removing.

INSTALLATION

Note the following items, and then install in the reverse order of removal.

CAUTION:

• Always replace double-sided tape with a new one, if rear emblem bracket is reused.

• Degrease rear emblem bracket mounting surface of tail lamp RH.

• Never wash the vehicle within 24 hours after installing so as to keep adhesive.

• If paint bumps, dust, etc., adhere to the emblem mounting surface, it may cause a defective appearance.

• Never reuse the emblem A and emblem B which was peeled.

NOTE:

Refer to the figure below for the emblem A and emblem B mounting position.

	Emblem A		Back door finisher		Back door panel
	Emblem B
	: R end

A	: 13.0 mm (0.512 in)	B	: 365.4 mm (14.386 in)	C	: 101.5 mm (3.996 in)
D	: 95.8 mm (3.772 in)	E	: 78.1 mm (3.075 in)	F	: 122.8 mm (4.835 in)
G	: 144.9 mm (5.705 in)	H	: 77.6 mm (3.055 in)